3Pcs inverter Boost High Voltage Generator 15KV High Frequency Transformer
$18.14
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Use
School science experiment, electronic equipment, negative ion generator, small scientific production and so on.
Feature
This circuit works to produce a stable high-frequency arc, the temperature is extremely high, can easily ignite the combustible, so it was called a plasma lighter.
Note
This transformer high voltage winding in the inner layer, is the segment skeleton wound, low voltage winding in the outer layer, please do not mistaken for this transformer is high voltage winding and low voltage winding the same way.
The transformer has two primary winding, one of the main group is coarse copper wire, a group of fine copper wire for the feedback winding. The secondary output is high voltage.
Transformers in a coarse and a thin winding together two copper wire is positive, respectively, the main winding tail and feedback winding head, connect the power supply positive.
Before soldering the transformer, the soldering part of the enameled wire head of the paint need to gently scraping with blade and then soldering, please note.
Precautions for product use
1. After the successful production, the transformer must be sealed with epoxy resin or insulating wax to be used for a long time. The air-borne work in the air will cause the coil to break through damage due to the lack of air insulation.
2. The input voltage of the kit is 3.7v. That is, a section 18650 battery voltage, if you need to increase the input voltage (maximum increase to 12V), you need to increase the feedback resistor resistance (we default send 120 ohm), otherwise the transistor is easy to burn. Feedback resistance increased to 150Ω ~ 1.5KΩ or so, the resistance should be adjusted from large to small, do not too small, otherwise will burn transistor or transformer, and should not be too large, too much will impact the output or make the transistor work in the non-switch state to make the fever is serious hot.
transformer design for the 15KV maximum output, which is 1.5 cm arc, the higher the output voltage is likely to damage the transformer. For reliable long-term continuous work, it is recommended to use insulating wax or epoxy resin to completely seal it, prohibit no-load working when no sealed.
Specification
Input voltage:3.7V-4.2V
Current
Output voltage
Output current
High pressure two-stage ignition distance
Size is about:27 x 16 x 21mm (Manual measurement, please understand the error)
Package includes
3 x High Voltage Generator Kit
Schematic diagram
In order to prevent the output 2-line distance too far, resulting in no-load, you can solder a pin in the output, and put the end of the needle into the arc, is conducive to the discharge arc, lik the following show
After the success of the production, if the output terminal connected to a high-voltage capacitor and three high voltage rectifier composed of voltage doubling circuit, can produce DC high voltage, can produce anion generator, the wiring diagram is as follows:
Weight | 0.054 kg |
---|
Customers Also Viewed
ESP8266 Development Kit with Display Screen TFT Show Image Or Word By Nodemcu Board DIY Kit
$32.79Smart ModuleAdd to cartDescriptionThis product kit can be used for some of the functions of the application of things, for example, display temperature and humidity, weather data display.TFT screen informationTFT screen and NodeMCU connection diagramPackage included1 x NodeMCU1 x 1.44 inch TFT screen8 x DuPont line
Band Pass RF Filter Band Pass 1420MHz BPF SMA-K
$93.91RF amplifierAdd to cartFeature1) Operating frequency:1420÷50MHz2) Insertion loss:1.8db3) Out-of-band suppression:40dB@50MHz4) Input impedance:50 ohm5) Output impedance:50 ohms6) Maximum input signal strength:13dbm (20mw)7) Input interface:SMA-K (SMA female)8) Output interface:SMA-K (SMA female)9) Dimensions:35*22*11mm10) Product weight:22gPackage includes1 x Band Pass RF Filter Band Pass 1420MHz BPF
XH-M548 2x120W Power Bluetooth Dual Channel Digital Amplifier Module TPA3116D2 Audio Amplifier Board
$28.42Amplifier BoardAdd to cartDescriptionThis product is a built-in TPA3116D2 chip with the power of 2*120W Bluetooth channel digital power amplifier board.SpecificationsParameterValueChipTPA3116D2Supply voltageDC12-24VOutput power120W*2 Supply currentMore than 3APower ratioMore than 90%Bluetooth moduleBTM835/CRS8635 (4.0 version)Transmission distanceMax 10M( without interfere)Vocal tract number2 channel (High bass control)switching frequency1.2MHzAppearance size98*80*18mmModels that support Bluetooth connectivityAndroid seriesIOS seriesWindows series Bluetooth connection methodTake mobile phone as …
3Pcs J03 LED Digital Time Delay Relay DC 6-30V on off Trigger Delay Timming Timer Switch Micro USB Power Supply 5V 12V
$32.79Relay ModuleAdd to cartFeatures1. Wide voltage power supply (6 ~ 30V), supports microUSB 5.0V power supply, easy to use;2. The interface is clear and simple, powerful, easy to understand, meet almost all your needs;3. The emergency stop function (“STOP’key);With reverse polarity protection, reverse polarity will not burn the product.4. Increase the sleep mode, if this mode is enabled, …
50pcs Scotch Lock Quick Splice 22-18 AWG Wire Connector Red
$8.99Terminal BlocksAdd to cartDescription50pcs Scotch Lock Quick Splice 22-18 AWG Wire Connector RedFeaturesEasy crimping with normal tool.Quick installation without striping wire job.Safety insulator tap.Suitable for Conductors in the rangeConductor CSA (Cross Sectional Area) 0.5 – 1.0mm², AWG (American Wire Gauge) 22 -18.Make Quick Connections without stripping.Easy crimping with normal tool, squeeze down the metal insert with pliers and …
50pcs Scotch Lock Quick Splice 22-18 AWG Wire Connector RedRead More
Excellway PCT-2 50pcs 2Pin Colorful Docking Connector Electrical Connectors Wire Terminal Block Universal Electrical Wire Connector
$54.66ConnectorsAdd to cart50pcs 2Pins Colorful Docking Connector Reusable Spring Terminal Block Electric Cable Wire Connector Main Features Wire connector. No wire loose, the risk of crisp tape, transparent and safe to see. With a test hole, measuring voltage, without removing the tape. Direct plug, insert the wrong can be pulled out, re-connected. Each contact point at the …
RIDEN 7 in 1 33V 10A Multifunction White OLED Digital Electrical Parameter Tester Ammeter
$26.23Power Supply ModuleAdd to cartSupport function:Voltage, Current, Time, Power, Temperature, Capacity, Energy, Run TimeFeatureOLED:WhiteVoltage:33VCurrent:10ANote:The measurement range are for reference match only, please check the value according to the voltage and current.Package includes1 x 33V 10A Electrical Parameter Tester
Reviews
There are no reviews yet.