inverter Boost High Voltage Generator 15KV High Frequency Transformer Arc Ignition Igniter Coil
$8.73
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Use
School science experiment, electronic equipment, negative ion generator, small scientific production and so on.
Feature
This circuit works to produce a stable high-frequency arc, the temperature is extremely high, can easily ignite the combustible, so it was called a plasma lighter.
Note
This transformer high voltage winding in the inner layer, is the segment skeleton wound, low voltage winding in the outer layer, please do not mistaken for this transformer is high voltage winding and low voltage winding the same way.
The transformer has two primary winding, one of the main group is coarse copper wire, a group of fine copper wire for the feedback winding. The secondary output is high voltage.
Transformer in a coarse and a thin winding together two copper wire is positive, respectively, the main winding tail and feedback winding head, connect the power supply positive.
Before soldering the transformer, the soldering part of the enameled wire head of the paint need to gently scraping with blade and then soldering, please note.
Precautions for product use
1. After the successful production, the transformer must be sealed with epoxy resin or insulating wax to be used for a long time. The air-borne work in the air will cause the coil to break through damage due to the lack of air insulation.
2. The input voltage of the kit is 3.7v. That is, a section 18650 battery voltage, if you need to increase the input voltage (maximum increase to 12V), you need to increase the feedback resistor resistance (we default send 120 ohm), otherwise the transistor is easy to burn. Feedback resistance increased to 150┯ ~ 1.5K┯ or so, the resistance should be adjusted from large to small, do not too small, otherwise will burn transistor or transformer, and should not be too large, too much will impact the output or make the transistor work in the non-switch state to make the fever is serious hot.
transformer design for the 15KV maximum output, which is 1.5 cm arc, the higher the output voltage is likely to damage the transformer. For reliable long-term continuous work, it is recommended to use insulating wax or epoxy resin to completely seal it, prohibit no-load working when no sealed.
Specification
Input voltage:3.7V-4.2V
Current
Output voltage
Output current
High pressure two-stage ignition distance
Size is about:27 x 16 x 21mm (Manual measurement, please understand the error)
Package includes
1 x High Voltage Generator
Schematic diagram
In order to prevent the output 2-line distance too far, resulting in no-load, you can solder a pin in the output, and put the end of the needle into the arc, is conducive to the discharge arc, lik the following show
After the success of the production, if the output terminal connected to a high-voltage capacitor and three high voltage rectifier composed of voltage doubling circuit, can produce DC high voltage, can produce anion generator, the wiring diagram is as follows:
Weight | 0.018 kg |
---|
Customers Also Viewed
WEAH-307 3 Way Audio Speaker Crossover 100W Filter Treble Mediant Bass Frequency Divider Module
$15.30Amplifier BoardAdd to cartFeatureMode:WEAH-307Power:100WImpedance:4-8ohmCompatible for:Under 6inches HornTreble Standard:12db/octBass Standard:12db/octSize:8.5×6.2×2.6cmFrequency response:low 45Hz, high 20KHzPackage includes1 x 100W Filter Treble Mediant Bass Frequency Divider
3pcs WXD3-13-2W Precision Potentiometer 22K 22K Ohm Wirewound Multi-Turn Potentiometer
$10.49Module ComponentsAdd to cartSpecificationsResistance range:22K┯Resistance tolerance:÷ 5%Rotation angle:3600 ÷ 20 Number of laps:10 lapsRated voltage:160VStarting torque:3.5 ~ 100mN.mRated power:2W (85 →) 0W (125 →)Linearity accuracy:÷ 0.3%Mechanical durability:10,000 weeksPackage included3 x Potentiometer
20Pcs Serial Port WIFI ESP8266 Module Adapter Plate with IO Lead Out for ESP-07 ESP-08 ESP-12
$12.02Smart ModuleAdd to cart20Pcs Serial Port WIFI ESP8266 Module Adapter Plate With IO Lead Out For ESP-07 ESP-08 ESP-12This Adapter Plate is for ESP-07 ESP-08 ESP-12, a test board with IO lead out.NoteNeed to solder 3V regulator by youself.ESP-07, ESP-08, ESP-12 module board are not included!!!Package included20 x Serial Port WIFI ESP8266 Module Adapter Plate40 x Pins
10pcs 2S 5A Li-ion Lithium Battery 7.4V 8.4V 18650 Charger Protection Board BMS for Li-ion Lipo Battery
$16.88Battery Protection ModuleAdd to cartSpecificationsModel:HX-2S-A2 Overcharge voltage range:4.25-4.35v ± 0.05vSize:17.5 * 17.5 * 3.2mm over discharge voltage range:2.5-3.0v ± 0.05vUpper limit operating current:5A Operating temperature:-40 — +50 °Upper limit instantaneous current:7A Storage conditions:-40– +80 °Quiescent current:less than 10uA Effective life:more than 50,000 hoursInternal resistance:less than 300mΩ Short circuit protection:can be protected, need to charge recoveryCharging voltage:8.4V-9VWelding point DescriptionB + …
DC 24V 600L/H Submersible Pump Immersible Pump Under Water Pump Bath Pump
$42.51Electrical Pump & ValveAdd to cartSubmersible Pump Immersible Pump Under Water Aquarium Bath Pump DC 24V 600L/HSpecificationColor:GreyUse:SubmersibleMaterial:Engineering ABSRated Voltage:DC 24VStarting Voltage:6VCurrent:0.75AFlow:600L/HNoise:50dB MAXMax. Head:500cmPower:18wWaterproof grade:IP68Motor:brush motorWater temperature:-20 ° C ~ 60 ° ° CAmbient humidity:45%~90%No load current:less than 0.2ACurrent at load:1.2ACable:1.5m /59.06inch(appr.)Total Length:105.9mm /4.31inch(appr.)FeaturesBrand New and high quality.Suitable for tap water, sea water, ground waterCannot be used directly with 220V AC …
DC 24V 600L/H Submersible Pump Immersible Pump Under Water Pump Bath PumpRead More
TDA7498 2.1 Digital Power Amplifier Board 200W+100W+100W Supasses TPA3116 Class D DC24V
$70.06Amplifier BoardAdd to cartFeatures-Using original TDA7498 TL072-The front input capacitor and the inter-stage coupling capacitor use Siemens’ top-level capacitors 1UF, the electrolytic capacitor signal main circuit uses Taiwanese famous brands, and the main filter capacitor uses special electrolytic capacitors 2≠2200UF to ensure strong continuous power support.-The resistors are high-precision chip resistors, and the main circuit uses five-ring metal …
TDA7498 2.1 Digital Power Amplifier Board 200W+100W+100W Supasses TPA3116 Class D DC24VRead More
3Pcs RobotDyn RTC DS1307 Real Time Clock Battery Shield with Pin Headers Set
$18.67Expansion Board & ShieldAdd to cartPINOUT:http://img.staticbg.com/file/products/20171226001032PINOUT-RTCDS1307.pdfSchematic:http://img.staticbg.com/file/products/20171226001140Schematic-RTCDS1307.pdfFeatureType:Logic ICsPackage includes3 x RTC DS1307 (real time clock) + battery3 x Wemos D1 mini shield6 x Male Pin Header 8pins6 x Female Pin Header -BLACK 8pins6 x Stackable Header – BLACK 8pins
Reviews
There are no reviews yet.