JK12-A 12V Time Adjustable Relay Module with LED Digital Tube Dynamic Display Countdown Single Chip Relay
$10.92
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Usage
This module starts work after triggering. If you need to set the power to start timing, then you can connect the two trigger lines directly.
inchTriggerinch is simply a touch of two lines. It can be a short touch or a long time. Timing starts when you touch each other.
K:Switching signal trigger, valid at the leading edge
RY:Relay
After power-on, RY has no action. After K is triggered, RY is immediately turned on. After the delay, the RY is disconnected after the countdown ends. When K is triggered again during the delay, it will immediately jump to the end of the delay (ie, RY is disconnected).
Features
– The button trigger type triggers the action to start immediately and delays. (If the button end is shorted before power-on, each power-on will be turned on and delayed by the setting)
– Display:The set time is displayed during adjustment; during the delay, the countdown is displayed dynamically.
– Switch on the load immediately after the trigger and disconnect the load after the specified time.
– During the delay, the button operation immediately stops the delay and returns to the initial state.
– During the delay, the digital tube reduces the brightness and counts down the delay to display the remaining time in real time.
– Set the time by adjustable resistor. The adjustable range is from 1 to 99. The unit can be selected by jumper. When the jumper is connected to the second, the adjustable range is 1-99 seconds. The jumper is connected to the time division. The adjustable range is 1-99 points.
– Board size:70mm x 40mm, height less than 18mm
Package Included
1 x JK12-A 12V Time Adjustable Relay Module with LED Digital Tube Dynamic Display
Weight | 0.029 kg |
---|
Customers Also Viewed
USR-ES1 W5500 Chip SPI to LAN Ethernet Converter TCP/IP Module WIZ820io
$15.30Converter BoardAdd to cart>>>Manual:Click here to openOverviewUSR-ES1 embeds Wiznet’s W5500 chip, which uses hardware logic gates to implement the transport layer and network layer of the TCP/IP protocol stack (such as TCP, UDP, ICMP, IPv4, ARP, IGMP, PPPoE, etc.), and integrates The data link layer, physical layer, and 32K bytes of on-chip RAM serve as data transceiving buffers. …
USR-ES1 W5500 Chip SPI to LAN Ethernet Converter TCP/IP Module WIZ820ioRead More
3pcs TEC1-12715 12V Heat Sink thermoelectric Cooler Peltier Plate Module
$32.04Electronic Accessories & SuppliesAdd to cart40 x 40mm TEC1-12715 12V Heatsink Thermoelectric Cooler Peltier Plate ModuleDescriptionSolid state, vibration free, noise-freeSimple to install and operateThe hot surface need to be good heat sinkSpecificationProduct name:thermoelectric cooler plate moduleModel:TEC1-12715Color:whiteCouples:127Voltage:12VUmax:15.4VImax:15AMax power consumption:231WTmax:70°CQcmax T=0(W):137WSize:40 x 40 x 3.3mmWeight:50gPackage included3 x TEC1-12715 cooler plate module
EQKIT KM-1 DC 6-12V PWM Motor Speed Controller Kit DIY Motor Speed Regulator Set Stepless Speed Control
$8.73Module KitsAdd to cartSpecificationsModel:KM-1Operating voltage:DC 6-12VPCB board size:40 x 40mmCircuit descriptionKM-1 uses PWM (pulse width modulation) to control the speed of the motor, adjust the pulse width duty ratio, so that the speed from zero to the maximum speed stepless speed regulation. The wider the crest width of the control waveform, the faster the motor speed; on the …
20pcs 63V 10000UF 105 High Frequency Temp Electrolytic Capacitor 30mm x 50mm Long Life
$108.62Electronic Accessories & SuppliesAdd to cartSpecificationModel:485622Voltage:63VCapacitance:10000UFTemperature:105→Diameter:30mm / 1.1 inchHeight:50 mm / 2 inchFeaturesLong life, high temperatureHigh-frequency capacitorsPackage included20 x Electrolytic Capacitor
Reviews
There are no reviews yet.