0.36 inch/0.56 inch PLC Controller Parameter LED Display Module D0 D2 PLC Programming Module Digital Tube Display

Usage Steps
1. The power register will always display the value mode of data register D0, D2 (D0 in the lower row, D2 in the upper row). Users can display different data by changing the value of D0 in the PLC ladder by MOV D D0 command.
2. When the MODE button is pressed for 1 second, the decimal point on the left will light up, then enter the mode of adjusting the data register number. At this time, increase or decrease the value by the two buttons on the right to adjust the number of the data register to be adjusted. If you want to set D128 to 100, then adjust to 128 in this step.
3. Press the MODE button again for 1 second, the rightmost decimal point will light up, then enter the mode of adjusting the value of the data register selected in the previous step, and also adjust the data register by increasing or decreasing the value by the two buttons on the right. Value, if you want to set D128 to 100, then adjust to 100 in this step.
4. When the MODE button is pressed for 1 second, the value mode of the data register D0, D2 (D0 in the lower row and D2 in the upper row) is displayed again.
5. When the UP button is pressed, the M171 is turned on and the UP button is released, then the M171 is disconnected.
6. When the DOWN button is pressed, the M172 is turned on and the DOWN button is released, then the M172 is disconnected.
7. When the RST button is pressed, the M173 is turned on. When the RST button is released, the M173 is turned off.
Package Included
1 x 0.36 Inch/0.56 Inch PLC Controller Parameter Display Module