Digital Voltmeter Ammeter Car Current Meter Dual Display 100V 10A DC Gauge Amperemeter Red+Yellow LED Tester Voltage Monitor
$9.42
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Technical Parameters
Display color:Red+Yellow
Display mode:Dual 0.28 LED digital tube
Update rate:About 500 ms/time
Physical size:48 x 29 x 26 mm (L*W* H)
Opening size:45 x 26 mm (L*W)
Supply voltage:3.5-30V
Lead wire length:14 cm(Five wires)
Measurement range:DC 0.00-9.99A(current) 0.0-100V(voltage)
Operation temperature:-10 degrees~65 degrees
Measurement accuracy:voltage ± (0.5% + 1digit) current ± (1% + 2digits)
NOTE
If you take long time to measure the current more than 6A, please weld the lead directly on the electrical outlet in case the instability of the circuit caused by the temperature of contact impedance!
Instruction of wiring
Red thin wire (VCC):Power input+ 3.5-30V (NOTE:If the measuring signal is lower than 30V and have abundant power supply, it can be used as power supply for the module [black wire and yellow wire are contacted together to use])
Black thin wire(GND):Power input- Measurement signal – 3.5-30V
Yellow thin wire (VIN):Measurement signal+ (0-100V)
Red thick wire (I+):Current input+ (connect with the load negative)
Black thin wire(I-):Current input- (in series in power supply negative)
Voltage current meter with isolated power supply
Instruction
Error phenomenon one:Because of the some eclectic parts ageing and influenced by the temperature, sometimes when measuring the small current, the error of some meter become big or sometimes some meter dont show zero without load.
Solution:When the meter is off the power, please short circuit A and B (connect A and B). Then make the meter have the electricity, the meter will automatically calibrated to zero. When the automatic calibration is over, please disconnect A and B. After this, that is ok.
Package included
1 x Digital Voltmeter
2 x cable
Weight | 0.021 kg |
---|
Customers Also Viewed
28.35ct 20x15mm Purple Oval Elliptical Cut Gemstone VVS AAA Jewelry Loose Gems Decorations
$20.24Lab Clamp & StandAdd to cartSpecificationsMaterial:ZirconColor:PurpleSize:20x15mmWeight:28.35ctClarity:VVS AAAShape:OvalFeatures– Transparent, bright;– Color is bright and the purity is positive;– Wide range of use;– Application for jewelry.Package Included1 Pcs x Purple Oval Cut Gemstone
5pcs CJMCU-250E BMA250E Sensor Module 3-axis Low G Acceleration Sensor Triaxial Accelerometer SPI IIC interface
$32.02Sensor & Detector ModuleAdd to cartFeatureThe BMA250E is a triaxial, low-g acceleration sensor with digital output for consumer applications. It allows measurements of acceleration in three perpendicular axes. An evaluation circuitry (ASIC) converts the output of a micromechanical acceleration-sensing structure(MEMS) that works according to the differential capacitance principle.Package and interfaces of the BMA250E have been defined to match a multitude …
JoyC Rocker Sensor Switch Module STM32F030F4 Control Chip Game Handle I2C Wireless Joystick Device
$54.05Motherboard & Development BoardAdd to cartDescriptionJoyC is a rocker module designed for the M5StickC.It supports two-hand operation. Embedded STM32F030F4 main control chip, using I2C communication protocol and host M5StickC for data transmission. The ran ge of the joystick is 0~200, there are 12 RGB LEDs under the left and right joysticks, and the bottom of the joystick is equipped with …
600-6000MHz UWB WiFi Ultra-wideband Log Periodic Antenna
$32.00RF amplifierAdd to cartSpecification1. Antenna frequency:600-6000MHz2. Antenna standing wave:less than 2 (typical value)3. Antenna polarization:directional linear polarization4. Antenna gain:6-7dB5. Power capacity:50W6. Dimensions:20≠20CM7. Weight:74 g8. Connector form:SMA-K (standard female, outer screw and inner hole)Package included1 x Antenna
Reviews
There are no reviews yet.