12V/24V/36V LCD Display Lead Acid Battery Capacity Meter Voltmeter Power Monitor
$38.46
Voltage 36V / Voltage 24V / Voltage 12V /
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specification
Material:Plastic Shell
Color:Grey+Blue
Size:As picture shown
Features
The open programming mode
The buzzer alarm(Selective assembly).
The low power red mark flashes to remind.
The product can go to sleep after 10 seconds.
The 10~100V wide input voltage,reverse protection.
The installation is simple, with a buckle, without screws.
Detection of the battery temperature (Selective assembly).
The color liquid crystal material, light clear display, display the soft night.
To display the percentage of remaining battery power,voltage, temperature value.
Suitable for lead-acid, lithium-ion batteries, lithium iron phosphate, metal hydride battery.
INSTRUCTIONS
1. PH2.0 terminal products supporting the use of wire, connected to the circuit board face should plug back.
2. External NTC temperature sensor, please put the sensor to measure the temperature of the parts, do not
squeeze the sensor( selective assembly).
3. Red line to the positive terminal, black line to the negative terminal.
4. After the instrument is powered on , which shows the percentage of the battery power, the voltage value,
and the symbols of the analog battery.
5. Press the button to turn off the instrument. In close mode, you can wake up the instrument by pressing
any button.
6. Click the button , you can switch the voltage value and temperature value display.
7. The battery symbols on the display interface, from the right to the left, are 7 display boxes representing the
pool power from low to high.
8. The voltage on the display interface is measured in real time, and the voltage value is displayed on
10-100V.
9. The percentage on the display interface is the percentage of the remaining battery power
10. When the battery is connected to the charger or the discharge of the high current load, the display
parameters will fluctuate
11. The red lightning flashes the alarm when the battery is low
12. Low voltage buzzer alarm(Selective assembly)
13. If the battery specification is special, you can enter the set mode 3– and reset the upper and lower limits of
the measured battery voltage.
Package included
1x Battery Monitor
1x Cable
Notice
Please allow 1-3cm error due to manual measurement and make sure you do not mind before ordering.
Please understand that colors may exist chromatic aberration as the different placement of pictures.
Weight | 0.027 kg |
---|
Customers Also Viewed
40x20x20cm Acrylic Display Box Clear Perspex Plastic Dustproof Base Transparent Case
$69.97DIY Electronic KitsAdd to cartFeatures– Made of acrylic material, clear and lightweight.– Simply design, very easy to install.– It is an wonderful display case, keep your collection figures tidy and clean.SpecificationsMaterial:AcrylicColor:TransparentSize:(L x W x H )21cm x 21cm x 41cm (8.3’x8.3’x16.1′)NOTEYou need to assemble the sheet into a box.Notice1. Please allow 1-3cm error due to manual measurement. Please make …
40x20x20cm Acrylic Display Box Clear Perspex Plastic Dustproof Base Transparent CaseRead More
3Pcs 1*40P Curved Needle Tin Plated Single Curved Needle 2.54MM Pin Connector
$2.15Module ComponentsAdd to cartSpecificationRoted Current:3.0AMPContocl Resistonce:20m┯ MaxWithstand Voltage:1000V AC/DCInsulation Resistance1000m┯ MinOperation Temperature:-40→ ~+105→Contact Material:BrassContact Plating:Tin over NiInsulator Material:Polyester(UL94V-0)Standard:PA6TMax.Processing Temp:230→ for 30-60 seconds(260→ for 10 seconds)Package included3 x 1*40P Single Curved Needle
3Pcs 315MHz XD-FST XD-RF-5V Wireless Transmitter Receiver Module Board Not Super-heterodyne
$6.80Smart ModuleAdd to cartTransmitter ModuleSpecificationWorking voltage:3V ~ 12VWorking current:20mA ~ 28mAStandby current:0mAWorking frequency:315MHzTransmitter distance:>500m (sensitivity can be above -103dBm if in wide field)Output power:16dBm (40mW)Transmitter rateModulation mode:OOK (AM)Working temperature:-10°C ~ +70°CSize:19 x 19 x 8mmFeatureStable performanceWider range of working voltagePinsPIN1 ATAD:data inputPIN2 VCC:power +PIN3 GND:power –ApplicationWireless calling system, burglar alarm, wireless data transmission, automated data acquisition systemReceiver Module …
3Pcs 315MHz XD-FST XD-RF-5V Wireless Transmitter Receiver Module Board Not Super-heterodyneRead More
6-30V 1 Channel Relay Module Switch Trigger Time Delay Circuit Timer Cycle Adjustable
$13.11Relay ModuleAdd to cartFeatures1. Trigger Signal Source:High Level Trigger (3.0 V-24 V), signal ground and system ground are not common, which can increase anti-interference abilitsystem (short circuit can also connect with a ground common)2. Output Capacity:can control no more than DC 30V 5A AC or 220 V devices 5A3. Optocoupler Isolation:improve the anti-interference ability, after the parameter setting, …
6-30V 1 Channel Relay Module Switch Trigger Time Delay Circuit Timer Cycle AdjustableRead More
3Pcs Wemos Motor Shield for WeMos D1 Mini I2C Dual Motor Driver TB6612FNGV1.0.0
$21.01Driver ModuleAdd to cartFeaturesI2C interfacePower supply voltage:VM=15V maxOutput current:Iout=1.2A(average) / 3.2A (peak)Standby control to save powerCW/CCW/short brake/stop motor control modesPins DescriptionVM:Motor power supply + (Max 15Vdc)GND:Motor power supply –A1 A2:Motor AB1 B2:Motor BS:Standby control port (in IO mode)More detail:Click Here!Package included3 x Motor Shield For WeMos D1 Mini
10Pcs TCRT5000 E2A3 1-Channel Smart Car infrared Tracking Sensor Detection PIR Sensor Module
$12.31Sensor & Detector ModuleAdd to cartProduct Usage1, the meter pulse data sampling2, fax machine shredder paper detection3, obstacle detection4, black and white line detectionProduct parametersInfrared reflection sensor:TCRT5000Detection reflection distance:1mm~25mmWorking voltage:5VOutput form:digital signal (0 and 1)Installation:with fixing bolt holesSmall board PCB size:3.5cm x 1cmSingle weight:4.5gFeaturesThe infrared emitting diode of the TCRT5000 sensor continuously emits infrared rays. When the emitted infrared rays …
5pcs DIY Technology invention Single-wing Wind Car Assembly Model DIY Car Kit
$28.96DIY Electronic KitsAdd to cartSpecificationsMaterial:WoodSize:approx. 12*7.6*12cmMulti-function:NoPower supply:2x AA Battery(not included)Foreign trade:YesDIY:Do it yourself according finished product painting in the package.ApplicationsInterest-building, parent-child communication, emotion, sensory,intellectual development, hands-on brain, hearing, interactive toys, grasping,hand-eye coordination, other abilitiesNote1.Please allow 1-3cm errors due to manual measurement.2.Due to the difference between different monitors, the pictures may not reflect the actual color of the item.Package Included5 …
5pcs DIY Technology invention Single-wing Wind Car Assembly Model DIY Car KitRead More
Reviews
There are no reviews yet.