5pcs QF-RD21 5V Power-off Delay Disconnect Relay Module Timer Delay Switch Module
Shipping:Standard Shipping about 10-25 business days
Voltage:5V DC (±1.5V)
Output:Passive output (ie dry contact), relay set of normally open + normally closed output. Do not exceed 10A at most.
Time range:(4 files, selected by switch)
First gear:range 0.2 seconds-30 seconds, accuracy:0.1 seconds
Second gear:range 0.2 seconds – 300 seconds (5 minutes), accuracy:0.3 seconds
Third gear:range 0.2 seconds-30 minutes, accuracy:1.8 seconds
Four gears:range 0.2 seconds – 300 minutes (5 hours), accuracy:18 seconds
Input:Voltage signal, above 1.5V is the effective signal, the current needs at least 0.1mA.
Dimensions:length 70mm * width 25mm * height 20mm
Screw hole:center distance 64.5, aperture 3.0mm
V+ module DC powered positive
GND The DC supply of the module is also the reference GND of the signal voltage.
IN signal voltage input, low level below 1V, high level above 1.5V, uncertain in the middle. Up to 30V
Normally open contact of the NO relay
Constant contact of NC relay
COM relay contact common
Time range setting
– When the selector switch is placed in the 30 position, it means 0-30 adjustable
– When the selector switch is placed at position 300, it indicates that 0-300 is adjustable.
Adjustment of time value
– Adjustable resistance rotates counterclockwise to the direction of the number to reduce the time, clockwise to the + direction increases the time
Time unit setting
– When the selector switch is placed in the Sec position, the unit is:second
– When the selector switch is placed in the Min position, the unit is:minute
Request a delay of 50 minutes
1. The range is placed at 300 position
2. The time unit is placed in the Min position.
3. Adjust the adjustable resistance to 50 position, adjust to 300, so adjust to 1/5 is 50.
Note:The potentiometer adjustment can also be quickly adjusted with the multimeter voltage file. For example, the range is 30, and it needs to be adjusted to 12, then the voltage can be adjusted to 2.
t=Ut/5*30=2.0V / 5.0V * 30 =12
Ut is the voltage measured by the multimeter, 30 is the range selected by the selector switch, and can also be selected to 300.
Combined with the travel switch and the inductive switch
1. Timeout automatically closes the door
2. Pipeline product flow monitoring
3. Current flow monitoring such as water flow
4. Other uses
5 x QF-RD21 5V Power-off Delay Disconnect Relay Module Timer Delay Switch
Customers Also Viewed
3pcs JDY-10 bluetooth 4.0 Module BLE bluetooth Serial Port Module Compatible with CC2541 Slave$16.47Other Module BoardAdd to cart
DescriptionModel:JDY-10 bluetooth 4.0 slave moduleKernel:M0Communication interface:serial portWorking voltage:1.9-3.6VCommunication distance:100 metersWorking current:90uaSuspen mode:14 uAModule is:bluetooth 4.0 slaveJDY-10 transparent transmission module is based on bluetooth 4.0 protocol standard, working frequency range is 2.4GHZ range, modulation mode is GFSK, maximum transmission power is 8db, maximum transmission distance is 80 meters, low power consumption, small size, strong signal, data …
3pcs JDY-10 bluetooth 4.0 Module BLE bluetooth Serial Port Module Compatible with CC2541 SlaveRead More
Plug&Play GPIO Expansion Board for Micro:Bit Open Development Board$17.74Raspberry Pi & Orange PiAdd to cart
OverviewThis is the Micro:bit GPIO Expansion board, it’s convenient to use micro:bit board; You can insert the expansion board directly into the micro:bit;You can cascade this expansion board.SpecificationsWeight:15gSize:6.4 x 3.7 x 1.2cmNotesThe micro:bit board is not included.Package Included1x Expansion Board
10pcs W25Q32 Large Capacity FLASH Storage Module Memory Card SPI interface BV FV STM32$16.08Other Module BoardAdd to cart
SpecificationsCapacity:32M-bit / 4M-byteThe clock frequency is less than 104MHzOperating voltage:2.7~3.6VSize:14mm * 15mmFeaturesUsing serial nor flash external expansion memory chip w25q64Support SPI InterfaceProvide STM32 test codePackage Included10 x W25Q32 Large Capacity FLASH Storage Module
HMC849 RF Switch Module Single Pole Double Throw 6GHz Bandwidth High Isolation$29.75RF amplifierAdd to cart
ParameterPower supply voltage:3-5VOperating frequency range:6GHZInsertion loss and isolation refer to the following S21 parametersModule size:2.5*3cm (without protruding SMA part)Input and output impedance:50┯Input and output SMA interface (outer spiral inner hole)Product weight:10 gPackage included1 x HMC849 RF Switch Module
0.1-2000MHz RF Amplifier Wideband High Gain 30dB Low Noise Amplifier LNA Broadband Module Receiver$21.86Amplifier BoardAdd to cart
FeaturesThis product with wide frequency range, high gain, low noise figureThis product can be applied to various rf receive front-end and increases the communication distanceUsed for Short wave, FM radio, remote control receiver, such as cable TV signal amplifier need low noise RF signal amplificationSpecificationsSize:25*52mmDiameter of end:5mmColor:green + goldOperating frequency:0.1-2000MHzAmplifier gainF=0.1MHz, gain=32dBF=500Mhz, gain=31dB F=1000MHz, gain=29dBF=1500Mhz, …
0.1-2000MHz RF Amplifier Wideband High Gain 30dB Low Noise Amplifier LNA Broadband Module ReceiverRead More
RC Resistance Surge Absorption Circuit Relay Contact Protection Circuit Electromagnetic$6.55Other Module BoardAdd to cart
OverviewRC absorption circuit module used on protecting the relay or thyristor because it can avoid damage thatfrom inductive electromotive force generated by the inductive load when on or off. Preventing electromagneticinterference and increasing the anti-jamming capability of the microcontroller.Description1, For AC or DC 5 ~ 400V inductive load (less than 1000W), protection relay contacts or …
RC Resistance Surge Absorption Circuit Relay Contact Protection Circuit ElectromagneticRead More
50pcs USB To DIP Female Head Mini-5P Patch To DIP 2.54mm Adapter Board$23.64Converter BoardAdd to cart
DescriptionMini USB is one of the most common USB interfaces at present. Compared with the standard USB, Mini USB is smaller and suitable for small electronic devices such as mobile devices. It has a wide range of uses. This module is easily transformed into the conventional DIP 2.54mm pin, which greatly facilitates your application.Package included50 …
50pcs USB To DIP Female Head Mini-5P Patch To DIP 2.54mm Adapter BoardRead More
There are no reviews yet.