PAM8403 DC5V 2x3W Digital Amplifier Module Dual Channel Power Stereo Amplifier Board
$4.60
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specifications
Supply voltage:DC 2V-5.5V
Distortion rate:1 (%)
Signal to noise ratio:90 (db)
Input impedance:2
Output impedance:4 (Ω)
Rated power:3 (W)
Frequency response:100Hz-15KHz
Efficiency:>90%
Number of channels:two channels
PCB Size:31x19mm
Note
1. The power supply voltage must not exceed the limit voltage of 5.5V. It is forbidden to reverse the power supply to avoid permanent damage to the chip.
2. This amplifier chip has built-in high-gain electronic volume control. Please adjust the volume to the middle position during debugging.
3. The maximum instantaneous dynamic current of this power amplifier board can reach 1.2A. It is strongly recommended to use a voltage of 5V and a power supply with a good filtering performance of 1A or more.
4. The speaker must be properly installed. Do not test directly with the speaker without the box, otherwise the ideal effect will not be achieved.
5. The output of this circuit is the BTL drive mode of the coms tube. The negative poles of the left and right speakers cannot be connected together, that is, the four lines connected to the speaker are completely independent and are not allowed to be shared.
Package Included
1 x 3W Stereo Amplifier Board
Weight | 0.006 kg |
---|
Customers Also Viewed
Excellway 11Pcs Terminal Removal Tool Kit Wiring Connector Pin Release Extractor
$14.16ConnectorsAdd to cart11pcs Terminal Removal Tool Kit Wiring connector Pin Release Extractor PullerBrand:Excellway®Color:BlackMaterial:AluminumFeature1.This kit set is designed to remove car wire terminals without damage.2.Please don’t Pry the terminals with this kit, Just push and pull the terminal pins.Packing Included1x 11pcs/set Wire Terminal Removal Tool
20pcs 0.36 inch DC0V-32V Blue LED Digital Display Voltage Meter Voltmeter Reverse Connection Protection
$67.74Test & Measuring ModuleAdd to cartFeature∵ Super high precision∵ Ultra-low startup voltage, red minimum 2.5V, green minimum 2.7V, blue minimum 3.0V. When the power supply voltage is lower than 3.5V, only the brightness is lowered, but the measurement accuracy is not affected.∵ With reverse connection protection, it will not burn.Measuring range:0.00V-32.0VPower supply range:Red DC2.50-32.0V, green DC2.70-32.0V, blue DC3.00-30.0VHighest input:DC32.0V. Note:If …
10Pcs 100mm OD 12mm 3mm Thick Wall Borosilicate Glass Blowing Tube
$30.36Lab TubesAdd to cartProduct DescriptionHigh quality borosilicate glass, Premium borosilicate tubing, preferred by scientific and artistic glassblowers world-wide. HEAVY wall tubing 10 pieces, 12mm outside diameter with a 3mm wall – all approximately 100mm long. This glass tube bends easily with propane (LPG) and oxygen mix. Brand new, high quality, heat and corrosion resistant. SpecificationName:10Pcs 100mm OD 12mm …
10Pcs 100mm OD 12mm 3mm Thick Wall Borosilicate Glass Blowing TubeRead More
VHM-306 TPA3118 2x30W 12-26V DC Stereo Audio bluetooth 4.2 Digital Power Amplifier Board for Amplifiers D3-001
$16.83Amplifier BoardAdd to cartSpecificationsModel:VHM-306 Audio input:DC12~36V Power amplifier chip:TPA3118 Bluetooth channel:stereo Output Power:30W*2Applicable impedance:4,6,8Ω AUX input:3.5 earphone holder Product Size:70*52*12mm Package Included1 x VHM-306 TPA3118 2x30W Bluetooth 4.2 Digital Amplifier Board
10pcs XD-M131 DC 12V Photosensitive Resistor Module Light Control Switch Photosensitive Relay Module
$49.09Relay ModuleAdd to cartSpecificationProduct model:XD-M131Product Name:photosensitive relay moduleOperating voltage:12VOutput mode:one channel relayOverall size:52 x 31 x 31mmDescription1. This product is mainly used for light detection, brightness detection and control and other occasions, through the potentiometer can be adjusted to detect brightness threshold. With the relay, it can do a variety of brightness detection switch, you can control a …
5pcs 1.8 inch LCD TFT Display Module with PCB Backplane 128X160 SPI Serial Port
$54.01Display ScreenAdd to cartFeatureResolution:128X160Driver IC:ILI9163/ST7735Module with regulator IC supports 3.2V/5V power supplyWith SD card holder, you can do experiments like digital photo frameThe module reserves the Nokia3310/5110 interface, supports the 1602 interface, and directly plugs in and out.IO for streamlined wiring:(only 3 IOs after optimization)1. RST– directly connected to the microcontroller reset signal terminal, this IO can save2. …
5pcs 1.8 inch LCD TFT Display Module with PCB Backplane 128X160 SPI Serial PortRead More
Reviews
There are no reviews yet.