LM3886 HiFi TF Stereo Amplifier Assembled AMP Board 68W+68W 4ohm 50W*2 / 38W*2 8ohm
$37.17
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specifications
NS LM3886 is a mono audio power amplifier chip, using an 11-foot TO-220 package, the back of the inchTFinch suffix is fully insulated package meant. And compared to LM1875T, LM3886 is more powerful, at the rated working voltage up to 68W continuous average power without distortion, also has a relatively perfect over-voltage over-current overheating protection function, in addition it has a function of current anti switch automatically when shock, the speaker may be possible to avoid current surge when the amplifier power is turned on causing injury.
LM3886 performance parameters
VCC = ± 28V OUTPUT = 68W / 4Ω, 38W / 8Ω
VCC = ± 35V OUTPUT = 50W / 8Ω
Peak power:135W
SNR:≥92db
Conversion rate:19V / us
Intermodulation distortion:0.04%
Mute function
SPiKeTM protection
The amplifier board has the following characteristics
1. Using double-sided alignment, careful layout, signal input portion away from the output section.
2. Part of the coupling capacitors for longer minimum pad 5mm, the maximum suitable for the capacitor of 10mm.
3. The input section added high pass circuit, making the board more stable!
4. The output part RL circuit (inductance and resistance in parallel) effective protection chip, effectively preventing the induced electromotive force shutdown speaker damage to the chip!
Materials used
1. Sheet glass fiber 1.6, size:106 * 54mm, chip pitch of 51mm. Widening output section traces, and left large electrical flow tin!
2. LM3886 (original disassemble) is insulated version without the installation of the insulation sheet! Use some grease on the line.
Installation note
1. The amplifier plate cannot connect directly to the transformer output end of the power plate, and then from the power board to the power supply panel, pay attention to the positive negative electrode level.
2. The plate uses DC power supply, speaker output impedance smaller current increases, the greater the heat, it is recommended when the speaker is 4Ω, the voltage suggested the use of ± 28V (transformer dual 21V). The speaker of 8Ω, voltage suggested ± 32V (transformer dual 24V), the highest possible ± 35V (transformer dual 28V), but pay attention to the local grid voltage is stable, it is recommended not to use.
3. When doing power test, the signal input on the board to the load, can not be suspended, otherwise it will may induction noise, the signal line to make use of shielded cable.
4. Be sure that the board chassis of the housing is connected to the input ground, if added to the front stage, the input stage is not necessary to draw a box, as long as the preceding stage input connected to chassis ground, then both will cause ground loops, noise.
Package includes
1 x HiFi LM3886 TF Stereo Amplifier AMP Assembled Board
Weight | 0.069 kg |
---|
Customers Also Viewed
12V 5.2W 165*210mm Mini Polycrystalline Solar Panel Epoxy Board
$26.57Smart Robot & Solar PanelAdd to cartFeaturesExcellent weak light effectIt is important electric parts for transferring the sun light power into electrical power for your applicationBuild your DIY powered models, solar display , solar light and solar toys, etcSpecifications– Material:Polycrystalline– Type:Epoxy solar panel– Maximum power:5.2 (W)– Working current:0-433mA– Working voltage:12V– Open circuit voltage:13.5V– Short circuit current:0.65A– Size:210*165*3(mm)– Reference weight:130gPackage included1 x …
12V 5.2W 165*210mm Mini Polycrystalline Solar Panel Epoxy BoardRead More
10Pcs RobotDyn TP4056 MicroUSB 18650 Li-Ion Battery Charger Module 1A with Power Connector and Cable
$24.26Battery Protection ModuleAdd to cartFeatureThe Micro-USB Li-Ion Battery Charger is a complete constant current/constant-voltage linear charger for single cell lithium-ion/Lithium Polymer (LiIon/LiPo) batteries. The Charger base on TP4056. The ideally suited for portable applications.And the Li-Ion Battery Charger can work within USB and 5V wall adapter. Other features include current monitor,under voltage lockout, automatic recharge, and two status pin …
10pcs 1 Channel 5v Relay Module High And Low Level Trigger
$23.61Relay ModuleAdd to cartDescriptionMaximum load:AC 250V/10A, DC 30V/10A.The chip optocoupler isolation, strong driving ability, stable performance, trigger current 5mA.Working voltage:5V.Every channel of the module can be set high or low level trigger by jumper.Fault tolerant design, even if the control line is disconnect, the relay will not act.Power indicator (green), 1 relay status indicator (red).The interface design is …
10pcs 1 Channel 5v Relay Module High And Low Level TriggerRead More
3pcs 1.25-36V 5A Constant Current Constant Voltage Lithium Battery Charger Step Down Power Module
$23.15Power Supply ModuleAdd to cartSpecificationsInput:IN + input positive, IN- input negativeOutput way:OUT + output positive, OUT- output negativeInput voltage:4-38VOutput voltage:1.25-36V continuously adjustableOutput current:adjustable, maximum 5AOutput Power:75W maximumWorking temperature:-40 to + 85 →Operating frequency:180KHzConversion efficiency:up to 96%Short circuit protection:Yes (limit current 8A)Overtemperature protection:(automatically shut off the output after overtemperature)Input reverse polarity protection:None, (if necessary, please enter the string into the …
Black Acrylic Case + Aluminum Heat Sink for Raspberry Pi Zero W/V1.3
$6.52Raspberry Pi & Orange PiAdd to cartDescriptionThis is the acrylic case specially made for raspberry pi board , both suitable for zero W and 1.3 version.Acrylic material is beatuful and a little fragile , please install it carefully , which is quite easy .And there is a layer of protective film on the surface of acrylic , so it is not …
Black Acrylic Case + Aluminum Heat Sink for Raspberry Pi Zero W/V1.3Read More
2L Non-Toxic Stainless Steel Enema Bucket Tools Kit Douche 2M Tube Reusable Medical Detox Enema Bucket
$78.96Lab Clamp & StandAdd to cartSpecificationName:2L Stainless Steel Enema Bucket KitMaterial:Stainless SteelType:Enema KitCapacity:2LColor:SilverFunction:Cleaning away Bacteria and Reduces the Risk of InfectionsSize:approx.19.5x13cmEnema Tube Length:1.6mFeatures– Large 2L capacity barrel, and you can adjust the water flow through the water control valve.– The enema bucket is reusable, durable, convenient and safe.– Big capacity can clean and vaginal thoroughly.– Cleaning away bacteria and reducing …
50pcs ULN2003 Stepper Motor Driver Board Test Module
$58.32Driver ModuleAdd to cartDescriptionULN2003 is a high voltage and high current Darlington transistor array products with high current gain, high operating voltage, wide temperature range, with strong load capacity and other characteristics, adapted to the requirements of various types of the high-speed high-power drive system.Features1. Using ULN2003 high-power Darlington chip-driven stepper motor2. Increased output expansion interface.3. A, B, …
50pcs ULN2003 Stepper Motor Driver Board Test ModuleRead More
240W 12V/24V 6-200AH Battery Charger for Lead Storage Battery Auto Charger Jump Starter Power Bank
$99.21AC/DC AdaptersAdd to cartFeatures– High power– Suitable for lead storage battery– Double screens– 8 safety protectionSpecifications– Power:240w– Voltage:12v/24v– Charging range:6-200AH– Size:205x140x222mmPackage included1x Battery charger (EU Plug)
Reviews
There are no reviews yet.