5pcs MQ-4 Methane Natural Gas Sensor Module Shield Liquefied Electronic Detector Module
$20.68
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specification
– The gas sensing material used in the MQ-4 gas sensor is tin dioxide (SnO2) with low conductivity in clean air.
– When there is a flammable gas in the environment where the sensor is located, the conductivity of the sensor increases as the concentration of flammable gas in the air increases.
– A simple circuit can be used to convert the change in conductivity into an output signal corresponding to the gas concentration.
– The MQ-4 gas sensor has high sensitivity to butane, propane and methane, and has a good balance between methane and propane.
– This sensor detects a wide range of flammable gases, especially natural gas, and is a low cost sensor for a variety of applications.
– Suitable for monitoring equipment for liquefied gases, natural gas and gas in the home or industry. Excellent resistance to ethanol and smoke.
Features
1. It adopts high quality double panel design with power indication and TTL signal output indication;
2. It has DO switch signal (TTL) output and AO analog signal output;
3. The TTL output valid signal is low. (When the output is low, the signal light is on, it can be directly connected to the MCU or relay module)
4. The voltage of the analog output, the higher the concentration, the higher the voltage.
5. It has good sensitivity to gas and natural gas detection.
6. there are four screw holes for easy positioning;
7. product dimensions:32 (L) * 20 (W) * 22 (H)
8. has a long service life and reliable stability
9. fast response recovery characteristics
Electrical Performance
Dection of gas:Natural gas/Methane
Dection of Concentration:300-10000ppm
Input voltage:DC5V
Power consumption (current):150mA
DO output:TTL digital quantities 0 and 1 (0.1 and 5V)
AO output:0.1-0.3V (relatively non-polluting), the highest concentration voltage is about 4V
Using the chip:AT89S52
Crystal:11.0592MHZ
Baud rate:9600
Compilation environment:Keil
Special Reminder
After the sensor is energized, it needs to be preheated for about 20S, and the measured data is stable. The heating of the sensor is a normal phenomenon, because there is a heating wire inside, if it is hot, it is not normal.
Package Included
5 x MQ-4 Gas Sensor Module
Weight | 0.035 kg |
---|
Customers Also Viewed
5pcs Blue Light Mini 0.36 inch DC Current Meter DC0-999mA 4-30V Digital Display with Reverse Connection Protection Ammeter
$43.50Test & Measuring ModuleAdd to cartFeatureModule name:Current display module:Measurement accuracy:0.10%Refresh rate:About 200ms – times:Display method:Three digits 0. 36inch digital tubeMeasuring range:0A-999mA:Power supply range:4V-30VWorking current:Less than 8mA:Display color:BlueStorage temperature:-10°C to +65°C:Input resistance:50 milliohmsWeight:10g:Peripheral size:35*14*10mmWiring diagram– The ground wire of power supply end and measuring end of this ammeter adopts common ground design, that is, the ground wire of the power supply …
ISD1820 3-5V Recording Voice Module Recording And Playback Module Control Loop Play / Jog Play / Single Play
$8.73Sensor & Detector ModuleAdd to cartDescriptions Main chip:ISD1820 Size:38.5 x 42.8mm Operating voltage:DC 3~5V Features Easy to use 10 second voice recording and playback. High quality, natural voice restore. Can be used as a megaphone module. With loop play, jog play, single play function. control. This module can directly drive 8 ohm 0.5W small speakers. Power supply:3-5V, can be connected …
15pairs MC Connector Male Female 30A 1000V with 1pair MC Spanner Solar Panel Branch Series Connect Solar System
$42.07Electronic Accessories & SuppliesAdd to cartDescriptionRated voltage:1000 V Rated impulse voltage:1000 V Rated current:24A – 14 AWG (2.5mm2;), 30A – 12 & 10 AWG (4mm2; & 6mm2😉 Test voltage:6 kV (50 Hz) Protection grade:IP67 Insulation material:PC/PA Contact material:Copper, silver-plated Operating temperature:-40°C ~ +90°C Safety class:II Flame class:UL94-V0 Contact resistance:≤5mΩ Insertion / Withdrawal force:≤50N / ≥50N Suitable for cables:10, 12, 14 …
10Pcs TJA1050 CAN Controller interface Module BUS Driver interface Module
$22.99Driver ModuleAdd to cartDescription1. onboard TJA1050 CAN controller interface chip2. chip commonly used pin has led, convenient connection to use3. pin 5 v to power supply4. PCB board size:22 (mm) x11.5 (mm)Package included10 x TJA1050 CAN Controller Interface Module
3.3V RC522 Chip IC Card induction Module RFID Reader 13.56MHz 10Mbit/s
$10.92Card ReaderAdd to cartDescriptionRC522 chipMF RC522 is applied to the highly integrated read and write 13.56MHz contactless communication card chip, NXP launched by the company for the ‘table’ application of a low-voltage, low-cost, small size of the non-contact card chip to read and write, smart meters and portable handheld devices developed better choice. The MF RC522 use of …
3.3V RC522 Chip IC Card induction Module RFID Reader 13.56MHz 10Mbit/sRead More
Reviews
There are no reviews yet.