ESP8285 ESP-1 Serial Wireless WiFi Transmission Module with ESP8266
$10.92
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Description
The WiFi module ESP-1 is manufactured by using a high-performance chip ESP8285.
This small chip is encapsulated an enhanced Tensilica’s L106 diamond series 32-bit kernel CPU with a SRAM.
Thus, ESP8285 has the complete function Wi-Fi function; it not only can be applied independent but can be used
as a slaver working with other host CPU. When ESP8285 is applied as a slave, it can start from the onboard Flash.
The built-in high-speed buffer is not only benefiting improve the system performance but optimizing the store system. In addition, ESP8285 can be used as Wi-Fi adapter by SPI/SDIO or I2C/UART interface, when it is applied to other MCU design.
, please visit this GitHub link to get the manual and tools, https://github.com/Smart/SZDOITWiKi/wiki/ESP8285—ESP-1
Features
Ultra-small size;
Support serial to WiFi;
Wireless transparent transmission;
Long distance transmission with ultra-low power;
Support outboard antenna;
Bearing high temperature to 125 →, compared to the 85→ for ESP8266.
Working temperature:-40→-125→
Module size:24.5mm*14mm;
SOC characteristics
Built-in Tensilica L106 ultra-low power consumption 32-bit CPU, the main frequency can be
80MHz and 160MHz, also support RTOS;
Built-in TCP/IP protocol stack;
Built-in 1 channel 10-bit high precision ADC;
The outside interfaces have HSPI, UART, I2C, I2S, IR Remote Control, PWM, GPIO;
The deep-sleep current is about 10uA, and the cut-off current is smaller than 5uA;
Can be wake-up within 2 ms, and connect to transmit data package;
the consumer power is smaller than 1.0mW (DTIM3) when at standby status;
built-in 1M byte for SPI Flash.
Wi-Fi characteristics
Support 802.11 b/g/n/e/i
Support three modes:Station, SoftAP, and SoftAP+STA;
Support Wi-Fi Direct(P2P);
Support hardware acceleration for CCMP (CBC-MAC, computation mode), TKIP (MIC, RC4),
WAPI(SMS4), WEP(RC4), CRC;
P2P find, P2P GO mode/GC mode and P2P power management;
WPA/PA2 PSK and WPS;
Support 802.11 i security:pre-certification and TSN;
Support 802.11n (2.4 GHz);
802.1h/RFC1042 frame encapsulation;
Support seamless roam;
Support AT remote updation and cloud OTA updation;
Support SmartConfig function for Android and iOS device SmartConfig.
Peripheral for Module
1*UART;
1*En;
MAX 4* GPIOs;
Application
Serial Transparent transmission;
WiFi probe;
Smart power plug/Smart LED light;
Mesh networks;
Sensor networks;
Wearable electronics;
Securit ID label;
Wireless location recognition;
Wireless location system beacon;
Industrial wireless control.
Package included
1 x ESP8285 ESP-1 Serial Wireless WiFi Transmission Module
Weight | 0.006 kg |
---|
Customers Also Viewed
10pcs ZF-1 ASK 315MHz Fixed Code Learning Code Transmission Module Wireless Remote Control Receiving Board
$33.80Smart ModuleAdd to cartFeatureProduct model:ZF-7 (with code)Transmission frequency:315MHZWorking voltage:DC 9V ~12VModulation method:ASKQuiescent current:0uAWorking current:30~45mACoding type:fixed code (SC2262)Radiated power:30~45mWTransmission distance:1000 meters (receiver sensitivity -108dBm)Volume:40mm*20mm*10mm:PIN:Description1:ANT:RF signal input pin, this pin should be connected to the antenna2:-:Negative power supply3:+:Positive power supply4:H-L:Digital pinRated parameter:Symbol:ValueDC supply voltage:VDD-VSS:9V-12VStorage temperature range (TS):TSTG:-12°C to 75°CWelding temperature:+260°CPackage includes10 x Receiver Board
2pcs Digital DC 0-100V 0-10A 250W Tester DC7-12V LCD Digital Display Voltage Current Power Meter Voltmeter Ammeter Amp Detector Geekcreit for Arduino – products that work with official for Arduino boards
$34.98Test & Measuring ModuleAdd to cartSpecificationsSimultaneous display of voltage and currentVoltage Measurement Range:DC 0-100VCurrent Measurement Range:0-10APower Measurement Range:0-1000WVoltage Error Range:÷1% (Adjustable)Current Error Range:÷1% (Adjustable)Power Error Range:÷1% (Adjustable)Refresh Rate:300ms/TimesDisplay Method:HTN LCD 3 Rows of 3 DigitsSupply Voltage:DC 7-12VWorking CurrentWorking Temperature:-10 to 60→Package Included2 x DC Digital Voltmeter Ammeter 4 x Cable
5pcs ESP8285 Development Board Nodemcu-M Based on ESP-M3 WiFi Wireless Module Compatible with Nodemcu Lua V3
$49.76Motherboard & Development BoardAdd to cartOverview1. It is fully compatible with Nodemcu V3, but cheaper than it is. NodeMcu is an open source firmware and development tool that helps you prototype your IOT products in several Lua script lines.2. The ESP8285-based development kit integrates GPIO, PWM, IIC, 1-Wire and ADC into a single board.3. The fastest way with the NodeMCU …
Vacuum Cleaner Charger Base for iRobot Roomba 5 6 7 8 9 Serie 595 780 880 860 980 960 Charger Base Dock
$85.04Solar CollectorsAdd to cartSpecificationName:Charger Base DockModel:C04612Material:Plastic Color:Black Size:As picture shownApplication Models:For iRobot Roomba 500/600/700/800/900Features-Let the robot automatically recharge when there is no power.-A good helper for family cleaning.Package Include1 x Charger Base Dock1 x Charger Cable
DC 12V 3.5mA Microphone Pickup Audio Microphone Amplifier Module DIY Kit Dual Track Output Gain Adjustable
$4.93DIY Electronic KitsAdd to cartDescriptionProduct name:Microphone with adjustable sensitivityWorking voltage:DC9-15V, 12V recommendedWorking current:above 100mAResponse frequency:20Hz-20KHzMonitoring range:about 100 square metersFinished product size:length 56 * width 25 * height 16mmProduct net weight:15 gramsThe power input has anti-reverse protection, which can effectively prevent the module from being damaged if the power is reversed.Product descriptionThis product uses a low-noise processing chip, plus a …
3pcs 5V LED Traffic Light Display Module Electronic Building Blocks Board
$4.85Display ScreenAdd to cartFeatureSize:56 x 21 x 11mmFixing hole:3mmPitch:15mmColor:red yellow greenLED:8mm x 3Brightness:Normal brightnessVoltage:5VInput:Digital levelInterface:common cathode, red, yellow and green separate controlPlatform:, microcontrollerPackage includes3 x LED Traffic Light Module
Upgraded Version 3D Light Cube Kit 8x8x8 Blue LED MP3 Music Spectrum DIY Electronic Kit
$72.16DIY Electronic KitsAdd to cartNote1. This product does not include housing!! if you need the housing, please purchased separately (Product ID:1247731).2. This is a DIY kit, you need to have some knowledge of electronics and ability.3. Need a lot of soldering, you should have enough patience.4. 8x8x8 blue lights display version.5. APP function only supports Android6. File:Click here to …
Upgraded Version 3D Light Cube Kit 8x8x8 Blue LED MP3 Music Spectrum DIY Electronic KitRead More
Reviews
There are no reviews yet.