SI24R1 NF-01-S 2.4G Wireless Serial Module Transparent Transmission
$6.55
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Description
NF-01-S is a 100mW power 2.4G wireless module, high-altitude rate (up to 2Mbps), using SPI interface, send and receive in one pure hardware module; high stability, cost performance, Volume, use of all-industry components.
Has been mass production and reached millions of shipments, and applies to a variety of application scenarios.
NF-01-S can be widely used in a variety of networking occasions, suitable for wireless mouse and keyboard, wireless remote control, somatosensory equipment, active RFID, NFC, low power consumption network of wireless sensor networks, is the ideal solution of Internet of Things application.
NF-01-S adopt DIP-8 package, whether learning or mass production, can quickly docked to existing products, no need soldering, direct plug, easy to use.
Information link:http://wiki.ai-thinker.com/2.4g
Features
• DIP-8 ultra-small package, built-in 2.4G antenna, small size, easy to use
• Supports data reception for six channels
• Supports common modulation such as GFSK / FSK
• Supports 2Mbps / 1Mbps / 250Kbps data rate
•Multi-frequency:126 frequency, to meet the needs of multi-point communication and frequency hopping communication
• Internal integration of high PSRR LDOs
• Wide supply voltage range:1.9 ~ 3.6V
• Average emission current as low as 110mA
• Receiver sensitivity:-96dBm @ 250kbps
• Maximum transmit power:+ 7dBm
• Four-wire SPI interface for up to 10MHz
• Internal Integrated Smart ARQ Baseband Protocol Engine
• Transmit data hardware interrupt output
• Supports 1bit RSSI output
• Low application cost:The SI24R1 integrates all the high-speed signal processing parts associated with the RF protocol, such as automatic retransmission of lost packets and automatic generation of response signals. The SPI interface of the SI24R1 can be connected using the microcontroller’s SPI port or using the microcontroller I / O port to simulate, the internal FIFO can be with a variety of high and low speed microprocessor interface, easy to use low-cost single-chip.
• Easy to develop:Since the link layer is fully integrated on the module, it is very easy to develop. Automatic retransmission function, automatic detection and retransmission of lost packets, retransmission time and the number of retransmission software can automatically control the automatic response is not received a reply signal packet automatic response function, after receiving the valid data, the module automatically sends a response Signal, no additional programming Carrier detection – Fixed frequency detection Built-in hardware CRC error detection and point-to-multipoint communication Address control Packet transmission error Counter and carrier detection function can be used for frequency hopping settings can be set at six simultaneous receive channel address, can be selective Of the open receiving channel standard pin DIP 2.54mm pitch interface for easy embedded applications.
Parameter
Model:NF-01-S
Package:DIP-8
Size:28.6*15.3*3.2 mm
Communication Interface:SPI (The maximum rate of up to 10Mbps)
Air rate:250k~2Mbps, 3 Level adjustable(250kbps,1Mbps,2Mbps)
Spectral range:2400MHz~2525MHz adjustable, 1MHz Step forward
Antenna form:Onboard PCB antenna, gain 2dBi
Maximum transmit power:7dBm
Receiving sensitivity:-96dBm@250kbps
Average current:Emission current:25mA(7dBm)
Receive current:15mA (2Mbps)
Shutdown:current 1.0uA(Shutdown Mode)
Power supply range:1.9~3.6V, Typical value 3.3V
Operating temperature:-20 → ~ 85 →
Storage environment:-20 → ~ 90 → ,
Pin Explanation
NO.:Name:Direction:Use
1:VCC:-:Power supply, must be between 2.0 ~ 3.6V
2:GND:-:Ground, connected to the power supply reference ground
3:CSN:Input:The module chip select pin, is used to start an SPI communication
4:CE:Input:Module control pin
5:MOSI:Input:Module SPI data input pin
6:SCK:Input:Module SPI bus clock
7:IRQ:Output:Module interrupt signal output, low level active
8:MISO:Output:Module SPI data output pin
Package included
1 x SI24R1 NF-01-S 2.4G Wireless Serial Module
Weight | 0.001 kg |
---|
Customers Also Viewed
CP2102 USB To TTL/Serial Module Downloader
$10.11Converter BoardAdd to cartCJMCU CP2102 USB To TTL/Serial Module UART STC Downloader For Driver Installation Introduction:http://forum.hobbyant.com/forum-topic-56275.html Description CJMCU-CP2102 its highly integrated, built-in USB2.0 full-speed function controller, USB transceiver, crystal oscillator, EEPROM and asynchronous serial data bus (UART), supports full-featured modem signal without any external USB devices. CJMCU-CP2102 works with other USB-UART adapter circuit similar to the driver through …
24x12x1 inch Aluminum Silicate High Temperature insulation Ceramic Fiber Blankets
$56.69FabricsFibers & TextilesAdd to cartDescription24x12x1 Inch Aluminum Silicate High Temperature Insulation Ceramic Fiber BlanketSpecificationMaterial:Aluminum SilicateSize:61x30x2.5cm / 24 x12 x1 inchClassification temperature:1260 ℃Long-term temperature:1100 ° CThermal conductivity:0.03Applications* Furnace, heating equipment, pipelines and other lining or wall lining insulation* Furnace door, lid, roof and other heat sealing* Chemical, electrical, high-rise building insulation fireFeatures* Seismic heat resistance* Low thermal conductivity and low …
24x12x1 inch Aluminum Silicate High Temperature insulation Ceramic Fiber BlanketsRead More
10pcs EQKIT AMP-1 TDA2822M Power Amplifier Amplify Module DIY Kit Electronic Production for Diy Kit Electronic PCB Board Module
$82.12DIY Electronic KitsAdd to cartDescriptionPackage Name:TDA2822M AmplifierKit Model:AMP-1Working voltage:DC4.5-9VPCB size:51*36mmSpeaker Size:50mmSpeaker Power:0.25WAMP-1 amplifier using TDA2822M acts as amplifier chip, this chip is STMicroelectronics (ST) developed dual-channel monolithic power amplifier IC, usually in the pocket cassette player (WALKMAN), tape recorders and multimedia speaker in for the audio amplifier. Has a simple circuit, good sound quality, wide voltage range and other …
5Pcs PS2 Game Joystick Switch Sensor Module
$10.92Sensor & Detector ModuleAdd to cart5Pcs PS2 Game Joystick Module For Description This is PS2 game joystick module for Lots of robot projects need joystick. This module provides a affordable solution to that. Simply connect to two analog inputs, the robot is at your commands with X,Y control. It also has a switch that is connected to a digital pin. …
100W Outdoor Sunpower Foldable Solar Panels Cells Waterproof Fast Charger Solar Panel
$97.19Solar PanelAdd to cartFeatures1. High efficiency, fast charging.2. Small size, super thin, waterproof, easy to operate, wide range of application3. Easy to carry, with a handle.4. It is more than 5% higher than ordinary efficiency.5. Solar energy conversion efficiency:25%Specifications–Output voltage:USB5V + DC18V–Output current:20A, 5.5A–Color:Black–Solar panel type:Monocrystalline silicon–Conversion efficiency:>25%–Output interface:USB–Open Size:680mmx305mm/26.7inx12in–Folding size:170mmx305mm/6.7inx12inPackage Included–1X Soalr Panel–2X Carabiner–1X USB cable
Reviews
There are no reviews yet.