OLED Version DevKit ESP32 Watch Development Board
$97.88
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
What is it
It is a ESP32 Watch development board.
Why did you make it
This product was planned at the same time of deauther wristband. I learned a lot of experience from deauther wristband and I knew ESP32 is a better choice for a ‘Watch’.
The break ou pads are also designed to connect different sensors.
TX/RX could be used to communicate with computer or other control board.
17/16 is IIC port could be connected with RTC module or other IIC sensors.
SVP/SVN could input ADC signals.
25/26 could output DAC signals.
What makes it special
Small size:3.8×4.5cm
Height:1.5cm
Double 4 layer board
600mAh battery inside
On/OFF Power Switch
OLED version:1.3OLED SH1106(SDA-17,SCL-16)
Buzzer-32
WS2812b RGB LED-33
Navigation Button(Up-19,Center-18,Down-5)
OLED version external slide button(22,23)
Highlight LED(27)
Indicate charging LED(On means Charging,OFF means Full)
Reset and Flash Button at Bottom board
Break ou GPIOs(TX,RX,17,16,SVP,SVN,25,26,GND,3V)
SD Card support
GPIO12–DAT2
GPIO13–DAT3
GPIO15–CMD
GPIO14–CLK
GPIO2–DAT0
GPIO4–DAT1
GPIO21–card
Tutorial
1.Install the environment for ESP32
2.Install OLED library
3.Install Adafruit NeoPixel Library
4.Code Example for oled version
Upload config
Package Included
1 x DSTIKE ESP32 Watch DevKit
| Weight | 0.095 kg |
|---|
Related products
3pcs STM32F407VET6 Development Board Cortex-M4 STM32 Small System ARM Learning Core Module
$85.90Motherboard & Development BoardAdd to cartTips:The USB cable is powered separately to the development board, not USB to serial port.FeaturesOnboard:SD card holderRTC battery:CR1220 (not includes)Wireless communication:NRF2401 interfaceData storage:W25Q16Support FMSC liquid interfaceMulti-user pressaAll CPUs – IO lead2.54mm integer double pitch pinChip introductionSTM32F407VET6Core:Cortex-M4 32-bit RISC;Features:Single-cycle DSP instructionsWorking frequency:168MHz, 210 DMIPS/1.25 DMIPS/MHzWorking voltage:1.8V-3.6VPackage:LQFP100Storage resources:512kB FIash, 192+4kB SRAMResources:3 x SPI, 3 x USART, 2 …
3pcs STM32F407VET6 Development Board Cortex-M4 STM32 Small System ARM Learning Core ModuleRead More
DSTIKE Deauther MiNi EVO ESP8266 Development Board 4MB ESP-07 1.3inch OLED+RTC DS3231
$41.54Motherboard & Development BoardAdd to cartWhat is itIt is an upgrade version of Deauther MiNiDifferenceDeautherMiNiV2DeautherMiNiEVOESP07:4MB:4MBPowerSwitch:NO:YESRTC:NO:DS3231Charging:TP4056x:TP5410Regulator:LM39100:AMS1117Why did you make itI released DeautherMiNiV2 for a long time. There are still some details could be improved. I changed + and – direction of connector so it is compatible with most of battery you can purchase. It uses PH2.0 connector and any 3.7V Li-Battery …
DSTIKE Deauther MiNi EVO ESP8266 Development Board 4MB ESP-07 1.3inch OLED+RTC DS3231Read More
Black Deauther Wristband NodeMCU ESP8266 Programmable WiFi Development Board
$113.47Motherboard & Development BoardAdd to cartWhat is it1. Deauther Watch is still an ESP8266 development board, but you can wear it like a smartwatch.2. This ESP8266 development board comes with a 600mAh battery, OLED display and a 3-way momentary slide switch.3. It comes installed with the latest ESP8266 Deauther software. With this software, you can perform different attacks to test …
Black Deauther Wristband NodeMCU ESP8266 Programmable WiFi Development BoardRead More
Customers Also Viewed
10pcs MAX9814 High Performance Microphone AGC Amplifier Module CMA-4544PF-W
$90.79Amplifier BoardAdd to cartSpecifications– Supply Voltage:2.7v-5.5v @ 3mA current– Output:2Vpp on 1.25V bias– Frequency Response:20Hz – 20KHz– Programmable Attack and Release Ratio– Automatic gain, selectable max from 40dB, 50dB or 60dB– Low Input-Referred Noise Density of 30nV/– Low THD:0.04% (typ)– Low Power Shutdown Mode– Built-in 2V low-noise microphone bias– -40°C ~ +85°C extended temperature rangePackage included10 x Microphone …
10pcs MAX9814 High Performance Microphone AGC Amplifier Module CMA-4544PF-WRead More
T-AMP 2 x 15W TA2024 Digital Audio Amplifier Board Mini AMP
$19.04Amplifier BoardAdd to cartFeature1. The power to more than 12V current 3A2. The speaker is best to use an impedance of 4 ohms, some of the high sensitivity3. For some signal level is relatively low tone, to add the preamplifier to play the effect4. Note the positive and negative can not be reversed, use the power supplyElectrical CharacteristicsIts …
T-AMP 2 x 15W TA2024 Digital Audio Amplifier Board Mini AMPRead More
Mega 2560 R3 ATmega2560-16AU Control Module without USB Cable
$44.54Motherboard & Development BoardAdd to cartDescriptionThis is compatible R3 Mega2560 ATmega2560-16AU control board without USB cableMega is an ATmega2560 as core microcontroller development board itself has 54 groups digital I / O input / output terminal (14 groups do PWM outputs), 16 sets of simulation than the input side, group 4 UARTs (hardware serial ports), using the 16 MHz crystal …
Mega 2560 R3 ATmega2560-16AU Control Module without USB CableRead More
20W 420*380*3mm Folding PET Monocrystalline Silicon Solar Panel with Cable Dual USB
$93.62Smart Robot & Solar PanelAdd to cartSpecificationsMaximum Power(Pmax):20WOpen Circuit Voltage(Voc):18VMaximum Power Voltage(Vmp):12vMaximum Power Current(Imp):1.1AMaximum System Voltage(Imp):1000vOutput:USB 5V & DC 18VQuantity of cell:36Cell Effcience %:20%Output Tolerance:±10%Size:425*380*3mmStandard Test Conditions:Irradiance 1000w/m2Temoerature 25.C,AM=1.5Package Included1 x Solar panel with cable
5pcs 8Channel DC 5V RS485 Modbus RTU Control Module UART Relay Switch Board PLC
$45.10Relay ModuleAdd to cartDescriptions– Operating Voltage:DC 5V(5V Version)– Operating Current:10-15MA– inchopeninch inchcloseinch inchMomentaryinch inchSelf-lockinginch inchInterlockinch inchDelayinch 6 Commands– Two instruction-control mode:AT command and MODBUS command– Under the AT command ,the maximum delay is 9999 seconds– Under the MODBUS command ,the maximum delay is 255 seconds– AT commands can be made serial HyperTerminal (serial assistant) Enter;– MODBUS commands can …
5pcs 8Channel DC 5V RS485 Modbus RTU Control Module UART Relay Switch Board PLCRead More
LT1083cp 7A AC 35V Rectifier Filter Power Supply Board DIY Home theater Sound Amplifier Voltage Regulator
$24.04Power Supply ModuleAdd to cartDescriptionLT1083CP feature description (emphasis):It is a linear step-down block. Although the voltage adjustment can be adjusted from 2.5V to 37V, it is recommended that the working differential pressure is within 10V, because the power consumption is proportional to the differential pressure, the greater the differential pressure, the more heat The larger the output current, the …
Reviews
There are no reviews yet.