JK12-A 12V Time Adjustable Relay Module with LED Digital Tube Dynamic Display Countdown Single Chip Relay
$10.92
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Usage
This module starts work after triggering. If you need to set the power to start timing, then you can connect the two trigger lines directly.
inchTriggerinch is simply a touch of two lines. It can be a short touch or a long time. Timing starts when you touch each other.
K:Switching signal trigger, valid at the leading edge
RY:Relay
After power-on, RY has no action. After K is triggered, RY is immediately turned on. After the delay, the RY is disconnected after the countdown ends. When K is triggered again during the delay, it will immediately jump to the end of the delay (ie, RY is disconnected).
Features
– The button trigger type triggers the action to start immediately and delays. (If the button end is shorted before power-on, each power-on will be turned on and delayed by the setting)
– Display:The set time is displayed during adjustment; during the delay, the countdown is displayed dynamically.
– Switch on the load immediately after the trigger and disconnect the load after the specified time.
– During the delay, the button operation immediately stops the delay and returns to the initial state.
– During the delay, the digital tube reduces the brightness and counts down the delay to display the remaining time in real time.
– Set the time by adjustable resistor. The adjustable range is from 1 to 99. The unit can be selected by jumper. When the jumper is connected to the second, the adjustable range is 1-99 seconds. The jumper is connected to the time division. The adjustable range is 1-99 points.
– Board size:70mm x 40mm, height less than 18mm
Package Included
1 x JK12-A 12V Time Adjustable Relay Module with LED Digital Tube Dynamic Display
Weight | 0.029 kg |
---|
Customers Also Viewed
Christmas LED Colorful Luminous Mask Stage Bungee USB Charging EL Cold Light Mask
$24.04EL ProductsAdd to cartDescriptionProduct Name:Colorful Luminous MaskProduct material:luminous sourceProduct size:19*10CMLight color:color gradient / breathing light dimming power supply mode:USB charging 3.7V, 400 mAProduct use time:charging for 1-2 hours, continuous light for about 10-12 hoursProduct unit weight:about 60 gramsPackage included1 x Christmas mask
20pcs N/O N/C Emergency Stop Switch Push Button Mushroom 4 Screw Terminals
$58.87Electronic Accessories & SuppliesAdd to cartSpecificationTwo switching circuits:1 Normally Open + 1 Normally Closed (DPST:Double-Pole-Single-Throw)Stackable contacts:mix and match to suit your needContact rating:600V / 10ANumber of terminals:4Panel cut out diameter:22mmDepth behind panel:44.5mmButton diameter:40mmPackage included20 x Emergency stop switch
USB to Pin Module USB interface Converter Board Electronic Building Blocks for
$3.67Converter BoardAdd to cartFeatureSize:24 x 21 x 10mmFixing hole:3mmPitch:600mil (15.24mm)Interface:A-type USB holderApply:Change the USB interface to pins, easy to connect the target devicePackage includes1 x USB to Pin Module
5pcs SHT21 Temperature and Humidity Sensor Module High Precision Environmental Measurement Smart Home
$53.30Sensor & Detector ModuleAdd to cart>>>Manual:Click here to openParameterWorking voltage:3VRelative humidity:0~100%RHTemperature:-40~+125°CCommunication method:IIC interfacePlease refer to the product manual for more information:Click here to open.Package includes5 x Sensor module
RF Wideband Low Noise Amplifier 0.1-2000MHz Gain 32dB High Frequency Amplifier with Shell
$81.72RF amplifierAdd to cartDescriptionThis amplifier has the advantages of wide frequency range, high gain, low noise figure, etc. It can be used in various radio frequency receiving front ends to increase the communication distance! Wide range of shortwave, FM broadcasting, remote control receivers, cable TV signal amplifiers and other places where low-noise and small-signal radio frequency amplification is …
RF Wideband Low Noise Amplifier 0.1-2000MHz Gain 32dB High Frequency Amplifier with ShellRead More
5pcs Miniature Digital Recording Voice IC Chip Module Movement Recorder Recording Pen Music Card
$19.64DIY Electronic KitsAdd to cartFeatureEasy to use 6 seconds voice recording, high quality, clear voice reduction, can be used as a micro recorder, recordingpen, megaphone, recording greeting card module, this module can drive 8 euro 0.5W speakers. Operating InstructionsRecording button; press and hold the button to stop recording (recording will begin to drop a sound), let go of recording …
Reviews
There are no reviews yet.