Solar Ultrasonic Repeller bird Outdoor Solar Ultrasonic Pest Animal Repeller PIR Repellent Garden Cat Dog Bird
$85.04
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Solar Ultrasonic bird repeller for garden LED flash Mole Ultrasound dog control fox rodent rats pest Mosquitoes animal 120db-Alert
3-in-1, Ultrasonic + Strong Light + 120bB Burglar Alarm.
Solar Power & Built-in Ni-MH Rechargeable Battery.
Weather-proof to work all year-round in all weather conditions .
Once Installation for permanent service!
INTSRUCTION
1. “ON Inch mode:Ultrasonic + Strong Light
The Passive Infrared Sensor(PIR) detects motion and triggers the ultrasonic speaker emitting a tone that people cannot hear but chases away common outdoor pests like dogs, cats, deer, raccoons, mice, skunks, squirrels and more. Also start the flash Repeller.
2. “ALARM Inch mode:Ultrasonic + Strong Light + 120bB Burglar Alarm
Infrared sensing head detects moving objects and triggers 120 dB alarm sound and ultrasonic sound and strong light at the same time to repel dangerous animals or evildoer.
3. “OFF Inch mode:For turn off the repeller
Specifications
Size:14×11.1×8.7cm (Stand:32cm)
Weight:430G
Power Mode:Built-n 4×2/3AA Ni-MH rechargeable Batteries.
Power Consumption (Working):15mA
Power Consumption (Standby):≤10uA
Ultrasonic Frequency:25-61KHZ
Alarm Sound:120dB
Coverage Area:8m / 30ft
ASSEMBLING
1. Unpack it and confirm that if all parts are present.
2. It`s designed for continuous use, with built-in 2/3AA size NI-MH rechargeable ba batteries
3. Once turned ON, the red-LED light and ultrasonic signal will activate for 15 seconds. Among the time , there is sound waves for 2.5 seconds at the beginning. At the same time , the white-LED lights flash blasting. Following this activation, the unit will go to stand-by mode.
4. The location should allow adequate sunlight to keep the batteries fully charged. And make sure that it`s within the effective range of the repeller .
5. For best results, please keep the repeller head roughly9-10 inches above ground.
6. Take care not to stress or break the repeller when installing in hard ground. It is a good idea to prepare the ground for the ground stake to avoid damage to the unit.
7. When the PIR sensor detects motion, red-LED light will be on, The ultrasonic signal and the white-LED lights will run for 15 seconds. Following this, the Repeller will return to stand-by mode.
8. When the device is working and the PIR sensor detects motion, the Device will run for other 15 seconds in the next time.
CAUTION
• Check for underground utilities like cables or wires before digging or installing to prevent personal injury, property damage or even death.
• Allow the ALARM Repeller to operate continuously for best results.
• Do not immerse repeller in water.
• Do not cover-up the PIR sensor.
• To clean the repeller, use a damp-soft cloth and mild soap with Water. Do not use harsh chemicals or abrasive cleaning agentsThat may damage the repeller.
Weight | 0.463 kg |
---|
Customers Also Viewed
Multiple Car Toys Magnetic Puzzle Box Book Educational Book Kids Learning Gift
$52.64MathematicsAdd to cartPackage included10 x Card76 x MagnetsFeatures1.Developing kids’ intelligence.2.Teaching kids to know more words.3.Easy for storage.SpecificationsColor:MulticolorMaterial:Paperboard, MagnetismSize:30x4x21.5cm
Basic Starter Kit UNO R3 Mini Breadboard LED Jumper Wire Button with Box for Geekcreit for Arduino – products that work with official Arduino boards
$18.62Module KitsAdd to cartDescriptionsPerfect for Shield Prototyping and TestingPlastic housing, metal contact clipsAccept wire with diameter 20-29AWGVolatge/current:300V/3-5A400 tie-point2 Power Lanes, Tie-point 1001 Double-strip, Tie-point 300Solderless Breadboard Size:82x55x8.5mmPackage included1 x Uno R3 Development Board1x 400 hole Breadboard10 x 220Ω resistor 5% carbon film10 x 1k resistor 5% carbon film10 x 10k resistor 5% carbon film10 x 100k resistor 5% …
3pcs ESP32-S WiFi + Bluetooth ESP32S Serial to WiFi Dual Antenna Module
$29.27Smart ModuleAdd to cartDescriptionThe main chip uses a low-power dual-core 32-bit CPU with a frequency of up to 240MHz and computing power of up to 600DMIPS.Default 32Mbit SPI Flash, 520KB SRAMSupport SoftAP and Station modeUltra-small 802.11b/g/n Wi-Fi + BT/BLE SoC moduleSupport UART/SPI/I2C/I2S/PWM/ADC/DAC, etc.Support for firmware upgrade (FOTA)Antenna supports onboard antenna or IPEX block outputPackage includes3 x Wifi module
Geekcreit 433MHz DC 12V 10A Relay 1CH Channel Wireless RF Remote Control Switch Transmitter with Receiver
$15.30Smart ModuleAdd to cartIf you need more Transmitter, please buy Product ID:1215079>>>Manual:Click here to openFeaturesEasy to install and easy to carryWith a slidable cover on the remote controlWith a hook on the remote controlUse Learning coding, stable and reliableThe wireless signal can pass through walls, floors and doorsYou can turn on or turn off the receiver with transmitter …
CO2 Refill Adapter Connector Kit W21.8-14 Thread Set for Filling SodaStream
$56.69Electrical Pump & ValveAdd to cartFeature*CO2 Refill Adapter is used to fill CO2 into your Sodastream tank.*Adjustable valve pin ensures compatibility with any cylinder valve variation.*Easy to install and use.*Made of high quality metal, high hardness and durable.Specification*Material:Metal*Color:Silver (As Pictures Show)*Inner Thread:TR21-4*Outer Thread:W21.8-14Package Contents1*CO2 Refill AdapterNotes:The real color of the item may be slightly different from the pictures shown on …
CO2 Refill Adapter Connector Kit W21.8-14 Thread Set for Filling SodaStreamRead More
30pcs 2.5-5.5V TTP223 Capacitive Touch Switch Button Self Lock Module
$15.15Other Module BoardAdd to cartFeatures 1. Size:15*11mm 2. Power:2.5-5.5V 3.Trigger setting mode:(1->Short;0->No Short) AB=00:No-lock High TTL level output; AB=01:Self-lock High TTL level output; AB=10:No-lock Low TTL level output; AB=11:Self-lock Low TTL level output; Package included 30 x 2.5-5.5V TTP223 Capacitive Touch Switch Button Self-Lock Module For
NE555 Pulse Module LM358 Duty and Frequency Adjustable Square Wave Signal Generator Upgrade Version
$6.55Test & Measuring ModuleAdd to cartFeature1. Used as a square wave signal generator to generate square wave signals for experimental development.2. Used to generate a square wave signal that drives the stepper motor driver.3. Generate adjustable pulses for use by the MCU.4. Generate adjustable pulses to control the associated circuitry.Description1. Size:3.5CM * 4.6CM1. The main chip:LM358;2. Input voltage:5V-12VDC.3. Input current:≥100MA;4. …
3pcs LM3915 Level indicator Kit DC9V-12V DIY Electronic Production Module Kit
$13.73DIY Electronic KitsAdd to cartFeatureModel:AUL-10Supply voltage:DC9V-12VAudio input:0~1.5VrmsPCB size:66 x 28mm (L x W)Light row size:62.5 x 5 x 10.7mm (L x W x H)Two indication modes:bar indication and fire spot indication (Realized by MOD short-circuit point)Lamp row offers two kinds of vertical and horizontal installationTin-treated solder padsNote:Before power on, please confirm the polarity of the power supply is correct …
3pcs LM3915 Level indicator Kit DC9V-12V DIY Electronic Production Module KitRead More
Reviews
There are no reviews yet.