XH-W1411 12V 10A Smart Electronics LED Digital thermometer Temperature Controller Switch Module
$16.02
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specifications
Temperature range:-55- + 120→
Temperature measurement accuracy:± 0.3→
Resolution:0.1→
Temperature range:-19 ~ 99→
Control accuracy:1→
Temperature probe:NTC10K / B3950 comes standard with 1 meter waterproof probe
Supply voltage:12V
Temperature:-25 ~ 55→ Humidity 20% -85% (non-condensing)
Output Type:10A relay outputs
Size:90*60mm/3.54 Inch*2.36 Inch
Hole size:70*50mm/2.76 Inch*1.96 Inch
Features
– The board and plastic panels fixed column compartment and lock nut
– Connect the power supply according to the drawings and load control line
– By drawing on the chassis opening 70 * 50mm, then tighten the screws after the thermostat embedded Paste Mask
– After power if the temperature in the interval starts immediately output to stop off value
– Start temperature For example, want to control the production of hot water, heated to 60 degrees stop, stop again begin heating to 45 degrees, then the start value should be 45 degrees, 60 degrees is stopped
– Start temperature> stop temperature = cooling mode
– For example, want to control greenhouse cooling, ventilation fans start when higher than 35 degrees, down 32 degrees when you stop, you start value should be set to 35, stop value is set to 32
– SET Function keys / Off button
1. In the boot state press SET 3s can shutdown, shutdown if the power remains off
2. Press SET to power in the off state, after boot if the power remains switched on
3.Short press SET to switch module temperature intermittent operation → → → reservation Power Off Timer (F1-F3 function independently, with the temperature does not matter, do not need to be able to do)
4. Left F-1 intermittent operation mode in minutes start minute, the right to stop minute
5. F-2 hour timer switch to the left, to the right minutes, maximum 99 hours 59 minutes
6. F-3 power appointment hours left, the right minutes, maximum 99 hours 59 minutes
7. Temperature correction:Unplug thermostat hold the SET power plug into the temperature correction function, the screen display –000– can subtract the temperature at temperature before correction on the basis of the maximum range -9.9 to 99,
8.After the calibration is complete:real-time temperature = temperature before correction + correction
9. Press and hold the (Start + -) power-on self-test function into
10.Press and hold (Stop + -) power to restore the factory settings
Reset
1. If errors or confusing settings, press and hold the power button to stop two restore factory settings
2. 88-888-88 display, buzzer flute sound, complete recovery
Package Included
1 x XH-W1411 Smart Electronics LED Digital Thermometer
Weight | 0.053 kg |
---|
Customers Also Viewed
WQ-BX-S2 Water Filter Activated Carbon Cartridge Replacement Refrigerator Filter for SAMSUNG
$52.64Switch AccessoriesAdd to cartSpecificationsMaterial:PC+Activated CarbonMin.Working pressure:207 kPa/30 psiMax.working pressure:689 kPa/100 psiMin.operating temperature:0.6°C/33°FMax.operating temperature:38°C/100°FRated service flow:0.5gpm(1.89L/min)Rated capacity:300 gallons(1136 liters)Features-Replace the filter every 6 months.-Made of coconut shell carbon fiber and PC,nice quality and filter performance.-Help to filter water,reduce residual chlorine and peculiar smell,which makes water taste better.-The refrigerator water filter have been tested and certified by NSF International against …
ESP32 OLED Module ESP32 OLED WiFi + bluetooth Dual ESP-32 ESP-32S ESP8266
$26.23Smart ModuleAdd to cartDescriptionESP32 is already integrated with antenna and RF balun, power amplifier, low noise amplifiers, filters, and the power management module.The entire solution is the least amount of PCB area. this board is 2.4 GHz dual mode WiFi and bluetooth chips by tsmc 40nm low power technology, power and optimized RF characteristics, which is safe, reliable, …
ESP32 OLED Module ESP32 OLED WiFi + bluetooth Dual ESP-32 ESP-32S ESP8266Read More
DIY Holographic Projection Building Block Virtual Imaging Blocks Toys
$19.97PhysicsAdd to cartName:DIY Holographic Projection Building Block Virtual ImagingModel:JY-WIZT00300SpecificationNet weight:189.4gPackaging size:395*285*5mmComposite finished product size:140*140*55mmColour:Log colourMaterial:WoodFeatures– Training of Practical Ability– Types of Science and Education:Physics– Intelligence trainingNote1. Because there may be slight deviation in manual measurement, please refer to the actual object.2. The picture is the finished product after installation and the shipment is the installation material package.3. …
DIY Holographic Projection Building Block Virtual Imaging Blocks ToysRead More
Laser Protective Goggles Glasses 405nm 445nm 650nm Red Blue Blue-violet Laser Eye Protection Safety
$26.31Laser Safety GlassesAdd to cartSpecificationName:Laser Protective GogglesMaterial:PlasticOptical Density (OD):OD4+Typical Laser Wavelength:650nm, 445nm, 405nmFeatures– Good protective performance, can filter 80% strong laser light.– Perfect for laser protection of 650nm red laser, 445nm blue laser, 405nm blue-violet laser.– Offer effective protection for your eyes in laser engraving operation.Package Included1 x Laser Protective Goggles1 x Storage Pouch
5Pcs Rain Sensor Water Level Measure Module Raindrop Analog Sensor Board
$12.88Sensor & Detector ModuleAdd to cartParameterWorking voltage:DC 5VWorking current:less than 35MAType:Analog SensorTest area:40 mm x 18 mmOperating temperature:10 → to 30 →Working humidity:10% – 90% No condensationFixing hole size:Φ3mmProduct size:60mm x 22mmApplicable occasions:Design of water level alarmFeatures:Simple, easy to use, small size, light, cost-effectivePackage includes5 x Rain Sensor
3pcs 36*IR LED Board for CCTV Camera Night Vision 60mm for CS LEN infrared Light Board DC12V
$12.06LED BoardAdd to cartSize ConversionInchesCentimetersPlease according to your own measurements to choose your suitable size. The tags inside the items will show in our Asian (Type) size.Description– Infrared IR LED boards for CCTV cameras night vision.– Power supply exceeds DC13V may greatly reduce the LEDs operating life.SpecificationsLED Number:36PCSBoard Diameter:60 mm (outside) / 34mm (inside)Power Supply:DC12V / 220mA (typical)Operation …
3pcs Low 3.5ohm PCA9306 Dual Bidirectional Voltage-Level Conversion Module Converter
$27.46Sensor & Detector ModuleAdd to cartDescriptionThis is a conversion board for the PCA9306 dual bidirectional voltage-level translator. Because different parts sometimes use different voltage levels to communicate, voltage level translators can be the key to making different parts play nice.The PCA9306 is a dual bidirectional I2C-bus and SMBus voltage-level translator that’s operational on the low side from 1.0 V to …
3pcs Low 3.5ohm PCA9306 Dual Bidirectional Voltage-Level Conversion Module ConverterRead More
Reviews
There are no reviews yet.