XH-W1411 12V 10A Smart Electronics LED Digital thermometer Temperature Controller Switch Module
$16.02
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specifications
Temperature range:-55- + 120→
Temperature measurement accuracy:± 0.3→
Resolution:0.1→
Temperature range:-19 ~ 99→
Control accuracy:1→
Temperature probe:NTC10K / B3950 comes standard with 1 meter waterproof probe
Supply voltage:12V
Temperature:-25 ~ 55→ Humidity 20% -85% (non-condensing)
Output Type:10A relay outputs
Size:90*60mm/3.54 Inch*2.36 Inch
Hole size:70*50mm/2.76 Inch*1.96 Inch
Features
– The board and plastic panels fixed column compartment and lock nut
– Connect the power supply according to the drawings and load control line
– By drawing on the chassis opening 70 * 50mm, then tighten the screws after the thermostat embedded Paste Mask
– After power if the temperature in the interval starts immediately output to stop off value
– Start temperature For example, want to control the production of hot water, heated to 60 degrees stop, stop again begin heating to 45 degrees, then the start value should be 45 degrees, 60 degrees is stopped
– Start temperature> stop temperature = cooling mode
– For example, want to control greenhouse cooling, ventilation fans start when higher than 35 degrees, down 32 degrees when you stop, you start value should be set to 35, stop value is set to 32
– SET Function keys / Off button
1. In the boot state press SET 3s can shutdown, shutdown if the power remains off
2. Press SET to power in the off state, after boot if the power remains switched on
3.Short press SET to switch module temperature intermittent operation → → → reservation Power Off Timer (F1-F3 function independently, with the temperature does not matter, do not need to be able to do)
4. Left F-1 intermittent operation mode in minutes start minute, the right to stop minute
5. F-2 hour timer switch to the left, to the right minutes, maximum 99 hours 59 minutes
6. F-3 power appointment hours left, the right minutes, maximum 99 hours 59 minutes
7. Temperature correction:Unplug thermostat hold the SET power plug into the temperature correction function, the screen display –000– can subtract the temperature at temperature before correction on the basis of the maximum range -9.9 to 99,
8.After the calibration is complete:real-time temperature = temperature before correction + correction
9. Press and hold the (Start + -) power-on self-test function into
10.Press and hold (Stop + -) power to restore the factory settings
Reset
1. If errors or confusing settings, press and hold the power button to stop two restore factory settings
2. 88-888-88 display, buzzer flute sound, complete recovery
Package Included
1 x XH-W1411 Smart Electronics LED Digital Thermometer
Weight | 0.053 kg |
---|
Customers Also Viewed
3Pcs 0.96 inch 4Pin White IIC I2C OLED Display Module 12864 LED
$38.88Display ScreenAdd to cartFeatureOLED Driver IC:SSD1306Resolution:128 x 64Visual Angle:>160°Input Voltage:3.3V ~ 6VCompatible I/O Level:3.3V, 5VMini Size:2.7 x 2.8cmOnly Need 2 I/O Port to ControlFull Compatible , 51NoteIf you decide to buy OLED display, you must confirm that you can make it work by yourself, we’ll haven’t any technology support. Thanks for your understanding and support.Package included3 x 0.96 …
3Pcs 0.96 inch 4Pin White IIC I2C OLED Display Module 12864 LEDRead More
Micro:Bit bluetooth 4.0 Low Energy Open Development Board for Programming
$60.06Raspberry Pi & Orange PiAdd to cartOverviewThe micro:bit is an open development board that allows you to run code on it and have access to all of the hardware.You can use your micro:bit for all sorts of cool creations, from robots to musical instruments – the possibilities are endless.This little device has an awful lot of features, like 25 red LED …
Micro:Bit bluetooth 4.0 Low Energy Open Development Board for ProgrammingRead More
500mL 24/40 Glass Filtering Flask Lab Filtration Conical Flask Bottle Laboratory Glassware
$58.71Glassware KitAdd to cartDescription– Flasks are glass or plastic containers for storing or collecting chemical samples or solutions in scientific laboratories.– It shaped like a cone with a wide, flat base that narrows to a neck opening, which can be closed with a stopper or cap.SpecificationMaterial:Borosilicate GlassCapacity:500mLFlask Style:Filtering (vacuum)Feature– The neck is 24/40 Ground Joint.Package Included1 x Glass …
500mL 24/40 Glass Filtering Flask Lab Filtration Conical Flask Bottle Laboratory GlasswareRead More
AC 100W 40KHZ Ultrasonic Cleaning Power Driver Board with 50W 40K Transducer 220V
$98.40Driver ModuleAdd to cartSpecificationsPower:220V 100WPendulum:50W 40KHZApplies to:Low-power ultrasonic cleaning machine, household cleaning machine, ultrasonic generator built machine.Features1. The ultrasonic generator can monitor the power system frequency ultrasound power.2. According to different requirements of users, real-time adjustment of various parameters, the power, amplitude, and running time.Circuit board and vibration head (ceramic transducer) Wiring instructions1. The board can not no-load …
AC 100W 40KHZ Ultrasonic Cleaning Power Driver Board with 50W 40K Transducer 220VRead More
5pcs 3S 18650 4A 11.1V BMS Li-ion Battery Protection Board 18650 Battery Charging Module Charger Electronic DIY
$19.48Battery Protection ModuleAdd to cartSpecificationsCharging Voltage:12.6V-13VOvercharge Voltage Range:4.25V-4.35V ± 0.05VOverpressure Voltage Range:2.3V-3.0V ± 0.05VUpper Limit Operating Current:3A-4AUpper Limit Instantaneous Current:9A-10AQuiescent Current:less than 30uAInternal Resistance:less than 100mohmEffective Life:more than 30,000 hoursOperating Temperature:-40- +50 degreesStorage Conditions:-40- +80 degreesSize:53 * 16 * 3mmShort Circuit Protection:protection, delay self-recovery ApplicationsThe power range is suitable for the following products:massager battery pack, LED light standby power …
3pcs infrared Light IR Camera Control Board for Surveillance Camera Night Vision CCTV Accessories
$10.52Driver ModuleAdd to cartSize ConversionInchesCentimetersPlease according to your own measurements to choose your suitable size. The tags inside the items will show in our Asian (Type) size.SpecificationsCurrent:700mAVoltage input:12V DCVoltage output:1.7-12V DCSize:38MM * 38MMPotential:good night vision effect; rigorous design, stable performance and strong anti-interference.Use:Suitable for all kinds of infrared lamp board drive, suitable for 1-6 infrared lampFunction:It can be …
Reviews
There are no reviews yet.