DC 12V-36V 15A 500W Brushless Motor Controller BLDC Driver Board Stall Over-current Protection
$30.60
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specification
Operating voltage:DC 12V-36V
Operating Current
Driver Power
Speed Voltage:0.1V-5V
Operating Temperature:-40~85°C
Humidity:90%RH
Stall protection:Yes
Enable Control:Yes
Over-current protection:Yes
Steering control:Yes
Speed control signal:Yes
Size:63 x 42 x 17mm (L x W x H); Probe size 3mm, length:fixing hole center distance 57mm; width:fixed hole center distance 36.5mm
Power terminal Out
VCC(positive power supply)
GND(negative one)
MC(motor phases W)
MB(motor phases V)
MA(motor phase U)
Set for the control side
GND:control terminal ground
VR:the governor end 0-5V(corresponding to 10% of motor speed -100%)
ZF:reversing control(connected to 5V or ground can charge the motor rotation direction)
M:tachometer pulse output(depending on the number of motor poles corresponding to the number of pulse per revolution of the output number)
EL:enable control terminal(connected to 5V ot ground running then 5V, grounding the motor stops)
5V:5V control terminal
Wiring
Control terminal for SET
1. The motor speed control wiring methods:available potentiometer system speed can also be connected to the MCU control, when the potentiometer control wiring, the potentiometer middle pin is connected to VR speed port, potentiometer connected to both ends of 5V and GND terminal voltage more high speed faster.
2. Motor steering control wiring methods:you can switch control can also be connected to the MCU control, to GND in one direction, then in one direction 5V.
3. Pulse speed signal:high and low output . IC can not understand the information with the customer request.
Note
Motor driver board 12-36V DC power input, VCC positive power supply,GND power supply is negative.
Electrical wiring methods:Brushless DC motor for the three lines, corresponding MA/U, MB/V, MC/W
Tips
If you use less than 60W, without additional heat sink , be sure to add more than 60W
heatsink fins drive efficiency without lowering the temperature is too high will shine into permanent damage! The size of the heat sink may be a bad environment based work(recommended cooling surface area greater than 200 square centimeters)!When installing the heat sink ,must pay attention to the back of the module 6 MOS pipe insulation, no insulation, it will be adhered to drive plate permanently damaged! Proposes to add insulation films, both sides of the insulating sheet plus thermal grease!
Package Includes
1 x 12-36V 500W Brushless Motor Controler
Weight | 0.027 kg |
---|
Customers Also Viewed
50pcs 3296W 50 ohm Trimpot Trimmer Potentiometer
$13.20Electronic Accessories & SuppliesAdd to cartSpecificationResistance:50 ohmPower (Watts):0.5W, 1/2W Tolerance:±10% Temperature Coefficient:±100ppm/°C Number of Turns:25 Adjustment Type:Top Adjustment Resistive Material:Cermet Mounting Type:Through Hole Termination Style:PC Pins Size / Dimension:9.53 x 4.83 x 10.03mmPackage included50 x Potentiometer
3pcs DC-DC 3V-35V To 4V-40V Step Up Power Module Adjustable Boost Converter Adjustable Voltage Board
$60.09Power Supply ModuleAdd to cartDescriptionInput Voltage:DC 3V-35VOutput Voltage:DC 4V-40V (continuously adjustable)Efficiency:94%(MAX)Size:L37mm*W32mm*H15mmWorking Temperature:-40-+85 degreesLoad capacity:Max 80WThe way of Connection:the connection terminal does not need to be soldered, the inchINinch is the input, and the inchOUTinch is the output.NoteWhen the output voltage is closer to the output voltage,the carrying capacity is higher,and the efficiency is also higher.Measurement reference tableInput voltage:Output voltage:Maximum …
AC110V-240V to DC12V 10A 120W Switching Power Supply 187*45*35mm
$28.42Power Supply ModuleAdd to cartParameterModel:S-120-12AC input voltage range:220VACInput current:0.5A/230VAC impulse current:Cold-start current 9A/230VDC output voltage:12VDC output power:120WRated output current:10AOutput voltage error:±1%Efficiency:85%Wave and noise:150mVp-pInlet stability:±0.5%Load stability:±0.5%Leakage currentOverload protection:105% – 150% rated power, automatically recoveryVibration:10500Hz,2G 10min./1cycle,Period for 60min,Each axesCooling method:Fan assisted cooling Working temperature and humidity:- 20 ° ~ 60 ° c / 20% ~ 90% RH (no frost)Store temperature and …
AC110V-240V to DC12V 10A 120W Switching Power Supply 187*45*35mmRead More
2.5W Oxygenator Air Pump Outdoor Solar Power Pond Aquarium Fish Tank Pool Pump
$91.11Electrical Pump & ValveAdd to cartFeatures-Small size, high energy, low noise, long life, AC / DC dual-use-With a belt buckle,easy to carry-Stable performance,strong volume-Built-in high quality rechargeable lithium battery,cycle life>=500 times-Less than 150mA ultra-low power,full power continuous supply of oxygen for more then 24 hours-External 5V power supply input,can simultaneously oxygen and charging,longer batter life-Using waterproof technology, effective protection of …
2.5W Oxygenator Air Pump Outdoor Solar Power Pond Aquarium Fish Tank Pool PumpRead More
HAWEEL 28W High Power Portable Solar Folding Bag Charging Panel with Dual USB
$153.05Smart Robot & Solar PanelAdd to cartFeatures1.Using the third-generation Sunpower solar panels imported from the United States, the photoelectric conversion rate is as high as 23% ~ 25%, and there is electricity when there is light.2. Dual USB output, charging speed 5V / 2.9A.3. High light transmission, tough and aging resistant material, worry-free charging.4. The external net bag can hold mobile …
HAWEEL 28W High Power Portable Solar Folding Bag Charging Panel with Dual USBRead More
12V 1500W Portable Car Truck Auto Heater Heating Cooling Fan Defroster Demister
$113.39Temperature ControllersAdd to cartFeatures– Integrated heating and cooling, water heating system.– 4 Air outlet, 3 big fan, and 2 water pipe connections.– Use for defrosting, demisting, deicing.– Provide the comforts for travel, camping, glass defrost mist.– It can be installed at the bottom of the seat, next to the foot, or at any position on the car.– With …
12V 1500W Portable Car Truck Auto Heater Heating Cooling Fan Defroster DemisterRead More
EleksMaker EleksZAxis Z Axis & Spindle Motor Drill Chunk integrated Set DIY Upgrade Kit for Laser Engraver CNC Router
$186.29Engraving Parts & AccessoriesAdd to cartWhat’s the improvement EleksZAxis 2019 is not only a Z axis holder, but also equipped with a spindle motor and a drill chunk which means it’s a more powerful and ready-to-use integrated set.EleksMaker® 555 spindle motor gives this kit stable and qualified power source.Unlike the other loose shaft coupler, JT0 0.3-4mm drill chunk is more …
Reviews
There are no reviews yet.