5pcs MQ-4 Methane Natural Gas Sensor Module Shield Liquefied Electronic Detector Module
$20.68
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specification
– The gas sensing material used in the MQ-4 gas sensor is tin dioxide (SnO2) with low conductivity in clean air.
– When there is a flammable gas in the environment where the sensor is located, the conductivity of the sensor increases as the concentration of flammable gas in the air increases.
– A simple circuit can be used to convert the change in conductivity into an output signal corresponding to the gas concentration.
– The MQ-4 gas sensor has high sensitivity to butane, propane and methane, and has a good balance between methane and propane.
– This sensor detects a wide range of flammable gases, especially natural gas, and is a low cost sensor for a variety of applications.
– Suitable for monitoring equipment for liquefied gases, natural gas and gas in the home or industry. Excellent resistance to ethanol and smoke.
Features
1. It adopts high quality double panel design with power indication and TTL signal output indication;
2. It has DO switch signal (TTL) output and AO analog signal output;
3. The TTL output valid signal is low. (When the output is low, the signal light is on, it can be directly connected to the MCU or relay module)
4. The voltage of the analog output, the higher the concentration, the higher the voltage.
5. It has good sensitivity to gas and natural gas detection.
6. there are four screw holes for easy positioning;
7. product dimensions:32 (L) * 20 (W) * 22 (H)
8. has a long service life and reliable stability
9. fast response recovery characteristics
Electrical Performance
Dection of gas:Natural gas/Methane
Dection of Concentration:300-10000ppm
Input voltage:DC5V
Power consumption (current):150mA
DO output:TTL digital quantities 0 and 1 (0.1 and 5V)
AO output:0.1-0.3V (relatively non-polluting), the highest concentration voltage is about 4V
Using the chip:AT89S52
Crystal:11.0592MHZ
Baud rate:9600
Compilation environment:Keil
Special Reminder
After the sensor is energized, it needs to be preheated for about 20S, and the measured data is stable. The heating of the sensor is a normal phenomenon, because there is a heating wire inside, if it is hot, it is not normal.
Package Included
5 x MQ-4 Gas Sensor Module
Weight | 0.035 kg |
---|
Customers Also Viewed
REX-C100 Digital RKC PID thermostat Temperature Controller 0 To 400 Degree K Type Relay Output
$24.04Electronic Accessories & SuppliesAdd to cartSize ConversionInchesCentimetersPlease according to your own measurements to choose your suitable size. The tags inside the items will show in our Asian (Type) size.FeaturesThis is a double universal programmable digital display temperature controller that supports many types of thermocouple sensor.It is powered by 220V ACSpecificationsScreen:Double screen for Celsius (C)Range:0-400C (Only when with K-type thermocouple factory)Thermocouple:K, …
High Gain 10dB 2.4G Wifi Directional Image Transmission Yagi Antenna
$20.07RF amplifierAdd to cartSpecificationWorking frequency:2.35-2.55GHZAntenna gain:10.5dB (typical value)Antenna standing wave ratioPower capacity:10WMechanical size:5x10Cm (excluding joints)Radiation direction:directional linear polarizationConnector type:SMA-K (standard female, outer screw and inner hole, can be customized)Package included1 x Antenna
20pcs DD2712SA 3.5A Mini 5V-27V to 12V DC DC Step Down Buck Power Converter Module Voltage Regulator
$83.70Boost & Buck ModuleAdd to cartDescriptionInput voltage:5-27VOutput voltage:5V Maximum output current:2.5AShort time maximum output current:3.5A Quiescent current:about 250uAWorking frequency:900KHz.Working efficiency:77-92% Size:25 x 15 x 6.3 mmOvertemperature shutdown, Under-Voltage Lockout (UVLO), BS-voltage protection, and short circuit protection.Note1. Input voltage can not be greater than the maximum input range.2. Output power can not be greater than the maximum load for a long …
Quick Charge 3.0 DIY Power Bank 18650 Battery Case QC3.0 5V 9V 12V DIY Kit Power Bank 2A 18650 Battery Fast Charger Shell
$25.14Module ComponentsAdd to cartNote1. Please Use flat-headed 18650 DIY2. If use the old battery,pls test the voltage,more than 3.5v and the Internal resistance less than 60 .3. It can’t use the flashlight 18650 battery4. Do not connect the positive and negative terminals backwards, otherwise it will burn the circuit board5. Don’t close the cover until the test is …
25x25x5cm Soundproofing Triangle Sound-Absorbing Noise Foam Tiles
$14.16FoamAdd to cartDescription25x25x5cm Soundproofing Triangle Sound-Absorbing Noise Foam TilesSpecificationsMaterial:Polyurethane foamDimensions:25 * 25 * 5 cm / 9.84 * 9.84 * 1.97 inchBlack:ColourQuantity:1pcFeatures– Bounce rate deformation, a long duration.– Waterproof, anti-moisture, good air permeability.– Wherever to help block sound and prevent echoes in the room.– These panels provide a strong noise reduction, good for studios, recording studios, vocal …
25x25x5cm Soundproofing Triangle Sound-Absorbing Noise Foam TilesRead More
Reviews
There are no reviews yet.