5pcs MQ-4 Methane Natural Gas Sensor Module Shield Liquefied Electronic Detector Module
$20.68
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specification
– The gas sensing material used in the MQ-4 gas sensor is tin dioxide (SnO2) with low conductivity in clean air.
– When there is a flammable gas in the environment where the sensor is located, the conductivity of the sensor increases as the concentration of flammable gas in the air increases.
– A simple circuit can be used to convert the change in conductivity into an output signal corresponding to the gas concentration.
– The MQ-4 gas sensor has high sensitivity to butane, propane and methane, and has a good balance between methane and propane.
– This sensor detects a wide range of flammable gases, especially natural gas, and is a low cost sensor for a variety of applications.
– Suitable for monitoring equipment for liquefied gases, natural gas and gas in the home or industry. Excellent resistance to ethanol and smoke.
Features
1. It adopts high quality double panel design with power indication and TTL signal output indication;
2. It has DO switch signal (TTL) output and AO analog signal output;
3. The TTL output valid signal is low. (When the output is low, the signal light is on, it can be directly connected to the MCU or relay module)
4. The voltage of the analog output, the higher the concentration, the higher the voltage.
5. It has good sensitivity to gas and natural gas detection.
6. there are four screw holes for easy positioning;
7. product dimensions:32 (L) * 20 (W) * 22 (H)
8. has a long service life and reliable stability
9. fast response recovery characteristics
Electrical Performance
Dection of gas:Natural gas/Methane
Dection of Concentration:300-10000ppm
Input voltage:DC5V
Power consumption (current):150mA
DO output:TTL digital quantities 0 and 1 (0.1 and 5V)
AO output:0.1-0.3V (relatively non-polluting), the highest concentration voltage is about 4V
Using the chip:AT89S52
Crystal:11.0592MHZ
Baud rate:9600
Compilation environment:Keil
Special Reminder
After the sensor is energized, it needs to be preheated for about 20S, and the measured data is stable. The heating of the sensor is a normal phenomenon, because there is a heating wire inside, if it is hot, it is not normal.
Package Included
5 x MQ-4 Gas Sensor Module
Weight | 0.035 kg |
---|
Customers Also Viewed
3pcs Geekcreit 3 in 1 AC 60-500V 100A Voltmeter Ammeter HZ Hertz Frequency Meter 22mm Digital Current Voltage Amp Signal Light Green LED Lamp indicator with CT
$30.29Electronic Accessories & SuppliesAdd to cartSpecificationsMaterial:ABS Electrical componentsColor:GreenVoltage Measuring Range:AC 60~500VCurrent Measuring Range:0~100AFrequency Measuring Range:20~75HzPanel Size:31*31mm / 1.22*1.22inInstallation Diameter:20.3mm / 0.8inPackage included3 x AC Voltmeter Ammeter Frequency Meter 3 in 1 Indicator3 x Current Coil Transformer
Waveshare 1.5 inch OLED Module SSD1327 Driver I2C Communication Compatible with Jetson Nano 128×128 General 1.5inch Display Board
$32.48Display ScreenAdd to cartDocumentsManual:Click here to openSchematic:Click here to openDatasheet:Click here to openCode:Click here to openOverviewThis is a general OLED display Module, 1.5inch diagonal, 128×128 pixels, 16 gray scale, with embedded controller, communicating via SPI or I2C interface.Features128×128 high resolution16 gray scale, better display effectSupports SPI or I2C interface, configured via onboard resistorComes with development resources and manual …
10Pcs TDA2030A 6-12V AC/DC Single Power Supply Audio Amplifier Board Module
$19.32Power Supply ModuleAdd to cartSpecifications1. Onboard TDA2030A audio power amplifier chip.2. Mono 18W power amplifier circuit design.3. Socket onboard horn .4. The onboard 10 k adjustable resistance, can adjust the volume of the amplification.5. The onboard power light.6. Chip has lead to the main pin, can directly input audio signal.7. Working voltage:6 – 12V.8. Board size:33 x 25 x …
10Pcs TDA2030A 6-12V AC/DC Single Power Supply Audio Amplifier Board ModuleRead More
L60 60A 12V/24V Auto LCD MPPT Solar Battery Charge Controller High Efficiency Solar Tracking System
$247.04Solar ControllersAdd to cartDescriptionThis is a three-time controller into the evening(evening)working time,an interval of rest or pause time,Dawn working time(morning light function),the user can according to their needs,set a different time.A:time(evening working)B:time(Pause working)C:time(dawn working)This is a compatible MPPT charge controller PWM intelligent/efficient/energy saving,he not only has efficient MPPT controller charging function to automatically track the maximum power point,10%-30% …
5pcs W5500 Ethernet Module TCP/IP Protocol Stack SPI interface IOT Shield Geekcreit for Arduino – products that work with official Arduino boards
$54.95Smart ModuleAdd to cartIntroductionThe W5500 is a full-featured TCP/IP embedded Ethernet controller that provides an easier Internet connection solution for embedded systems. The hardware logic gates are used to implement the transport layer and network layer of the TCP/IP protocol stack (eg TCP). , UDP, ICMP, IPv4, ARP, IGMP, PPPoE and other protocols), and integrated data link layer, …
5 Blade Heat Self-Power Stove Fan Wall Mounted Magnetic Fireplace Eco Fan
$131.61Temperature ControllersAdd to cartFeatures1. Longer service life – the entire fan is made of aluminum alloy and will not rust or corrode when heated.Quiet – the only moving part is the blade assembly. You don’t even know the fan there, but you will feel warm!2. No battery or power is required – the stove fan uses the heat …
5 Blade Heat Self-Power Stove Fan Wall Mounted Magnetic Fireplace Eco FanRead More
Reviews
There are no reviews yet.