5pcs MQ-4 Methane Natural Gas Sensor Module Shield Liquefied Electronic Detector Module
$20.68
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specification
– The gas sensing material used in the MQ-4 gas sensor is tin dioxide (SnO2) with low conductivity in clean air.
– When there is a flammable gas in the environment where the sensor is located, the conductivity of the sensor increases as the concentration of flammable gas in the air increases.
– A simple circuit can be used to convert the change in conductivity into an output signal corresponding to the gas concentration.
– The MQ-4 gas sensor has high sensitivity to butane, propane and methane, and has a good balance between methane and propane.
– This sensor detects a wide range of flammable gases, especially natural gas, and is a low cost sensor for a variety of applications.
– Suitable for monitoring equipment for liquefied gases, natural gas and gas in the home or industry. Excellent resistance to ethanol and smoke.
Features
1. It adopts high quality double panel design with power indication and TTL signal output indication;
2. It has DO switch signal (TTL) output and AO analog signal output;
3. The TTL output valid signal is low. (When the output is low, the signal light is on, it can be directly connected to the MCU or relay module)
4. The voltage of the analog output, the higher the concentration, the higher the voltage.
5. It has good sensitivity to gas and natural gas detection.
6. there are four screw holes for easy positioning;
7. product dimensions:32 (L) * 20 (W) * 22 (H)
8. has a long service life and reliable stability
9. fast response recovery characteristics
Electrical Performance
Dection of gas:Natural gas/Methane
Dection of Concentration:300-10000ppm
Input voltage:DC5V
Power consumption (current):150mA
DO output:TTL digital quantities 0 and 1 (0.1 and 5V)
AO output:0.1-0.3V (relatively non-polluting), the highest concentration voltage is about 4V
Using the chip:AT89S52
Crystal:11.0592MHZ
Baud rate:9600
Compilation environment:Keil
Special Reminder
After the sensor is energized, it needs to be preheated for about 20S, and the measured data is stable. The heating of the sensor is a normal phenomenon, because there is a heating wire inside, if it is hot, it is not normal.
Package Included
5 x MQ-4 Gas Sensor Module
Weight | 0.035 kg |
---|
Customers Also Viewed
10Pcs 50cm Fishing Lures 316 Stainless Steel Wire Trace Leader Spinner Swivel Line
$14.16Switch AccessoriesAdd to cartSpecificationMaterial:316 Stainless steel & nylonColor:RedLength:50cmQuantity:10pcs/setFeatures-With black nickel rolling swivel and cross lock snap-Durable enough to prevent breakage of the wire when the fish is fighting-Capable to handle up to 50kgPackage Includes10x trace wires
5pcs 12-60V Car Lead Acid Battery Charge Level indicator Battery Tester Lithium Battery Capacity Meter Dual Red LED Tester Digital Voltmeter
$22.60Electronic Accessories & SuppliesAdd to cartDescriptionThis power meter is suitable for 12V, 24V, 36V, 48V, 60V, battery cars (not waterproof). It can also measure lithium batteries, polymer batteries, nickel-metal hydride batteries. Can also be used for other power / voltage measurement purposes.How to use:Connect the positive and negative terminals of the display board to the positive and negative terminals of …
5Pcs PCI-E 6-pin To 2x 6+2-pin Power Splitter Cable PCIE PCI Express
$19.22Electronic Accessories & SuppliesAdd to cartDescriptionConnect any graphics card to a single 6-pin PCI-Express Power Cable. The 6+2-pin maleconnectors offer maximum versatility.Warning:Do not overload your power supply or the 6-pin power cable, running more than 300Wover a single 6-pin 18AWG PCI-Express cable is a fire hazard.Connectors:6-pin PCIe Female, 5x 6+2-pin PCIe MaleLength:8 inches / 20cmWire:18 AWG copperPackage included5 x PCI-e …
5Pcs PCI-E 6-pin To 2x 6+2-pin Power Splitter Cable PCIE PCI ExpressRead More
DC 12V 4CH Wireless Remote Control Relay Switch 2 Transceiver with 1 Receiver 315MHz
$19.67Smart ModuleAdd to cartFeaturesIt is a learning code wireless remote control switch (receiver), the output way /working way can be changed as you like, it is easy to match the transmitter. It has 4 Relays which can make the equipment turn or reverse, on/off and so on come true. The volume is small and the performance is stable …
DC 12V 4CH Wireless Remote Control Relay Switch 2 Transceiver with 1 Receiver 315MHzRead More
5pcs 2.4G NF-04 Wireless SPI Module BK2425 250k~2Mbps Transparent Transmission Receiver for Doorbell Remote Control Switch
$11.42Smart ModuleAdd to cartIntroductionNF-04 is a 2.4G wireless module with small size and on-board antenna. It has a high airspeed (up to 2Mbps), SPI interface, and a pure hardware module. It has high stability, high cost performance and good spectrum test characteristics. , small size, using all industrial grade components.NF-04 can be widely used in various Internet of …
PEB-1 Expansion Board +TSOP48 Socket + FPC Row Line FPC Base
$83.13Electronic Accessories & SuppliesAdd to cartFeaturesPEB – 1 extension board, supporting RT809F use, support notebook IT8586E/IT8580E models such as EC, support the notebook, computer motherboards commonly used 32/40/48 feet BIOS chips (29/39/49/50 series FWH/LPC / 8 bit / 16 bit NOR flash), contact with pin detection, automatic identification of short circuit protection and unique features, to read and write speed …
PEB-1 Expansion Board +TSOP48 Socket + FPC Row Line FPC BaseRead More
Smart Robot Chassis Car Kit with 2Pcs Motor+ Speed Encoder + Battery Box for Arduino – products that work with official Arduino boards
$26.57Smart Robot & Solar PanelAdd to cartFeaturesMechanical structure is simple, it is easy to install.This car is the tachometer encoder.Can be used for distance measurement.Can use with other devices to realize function of tracing, obstacle avoidance, distance testing, speed testing, wireless remote control.Download:www.uctronics.com/download/U3800.zipMotor ParametersVoltage:DC 3V:DC6V:DC 7.2VCurrent:160mA:220mA:250mANo-load Speed:120 rpm/min:200 rpm/min:250 rpm/minLoad Speed:100 rpm/min:175 rpm/min:210 rpm/minTorque:0.45 kg.cm:1.0 kg.cm:1.5 kg.cmReduction Ratio:1:48Noise:65dBMotor Size:65mm x 18mm …
3Pcs Fever Debuggable HIFI Speaker High and Low Sound 2-way Speaker Audio Crossover Kit
$21.65DIY Electronic KitsAdd to cartDescriptionHigh and low sound two-way, can be used for home audio, or car audio. High-quality components, fine workmanship. The four modes of high and low sound are adjustable, the whole process is free of welding, the use is simple and convenient, and the distribution of high and low sounds is more precise.Size:45*28mmPackage included3 x Two-way …
3Pcs Fever Debuggable HIFI Speaker High and Low Sound 2-way Speaker Audio Crossover KitRead More
Reviews
There are no reviews yet.