3pcs MQ-4 Methane Natural Gas Sensor Module Shield Liquefied Electronic Detector Module
$13.03
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specification
– The gas sensing material used in the MQ-4 gas sensor is tin dioxide (SnO2) with low conductivity in clean air.
– When there is a flammable gas in the environment where the sensor is located, the conductivity of the sensor increases as the concentration of flammable gas in the air increases.
– A simple circuit can be used to convert the change in conductivity into an output signal corresponding to the gas concentration.
– The MQ-4 gas sensor has high sensitivity to butane, propane and methane, and has a good balance between methane and propane.
– This sensor detects a wide range of flammable gases, especially natural gas, and is a low cost sensor for a variety of applications.
– Suitable for monitoring equipment for liquefied gases, natural gas and gas in the home or industry. Excellent resistance to ethanol and smoke.
Features
1. It adopts high quality double panel design with power indication and TTL signal output indication;
2. It has DO switch signal (TTL) output and AO analog signal output;
3. The TTL output valid signal is low. (When the output is low, the signal light is on, it can be directly connected to the MCU or relay module)
4. The voltage of the analog output, the higher the concentration, the higher the voltage.
5. It has good sensitivity to gas and natural gas detection.
6. there are four screw holes for easy positioning;
7. product dimensions:32 (L) * 20 (W) * 22 (H)
8. has a long service life and reliable stability
9. fast response recovery characteristics
Electrical Performance
Dection of gas:Natural gas/Methane
Dection of Concentration:300-10000ppm
Input voltage:DC5V
Power consumption (current):150mA
DO output:TTL digital quantities 0 and 1 (0.1 and 5V)
AO output:0.1-0.3V (relatively non-polluting), the highest concentration voltage is about 4V
Using the chip:AT89S52
Crystal:11.0592MHZ
Baud rate:9600
Compilation environment:Keil
Special Reminder
After the sensor is energized, it needs to be preheated for about 20S, and the measured data is stable. The heating of the sensor is a normal phenomenon, because there is a heating wire inside, if it is hot, it is not normal.
Package Included
3 x MQ-4 Gas Sensor Module
Weight | 0.021 kg |
---|
Customers Also Viewed
5pcs DD2712SA 3.5A Mini 5V-27V to 3.7V DC DC Step Down Buck Power Converter Module Voltage Regulator
$22.52Boost & Buck ModuleAdd to cartDescriptionInput voltage:5-27VOutput voltage:5V Maximum output current:2.5AShort time maximum output current:3.5A Quiescent current:about 250uAWorking frequency:900KHz.Working efficiency:77-92% Size:25 x 15 x 6.3 mmOvertemperature shutdown, Under-Voltage Lockout (UVLO), BS-voltage protection, and short circuit protection.Note1. Input voltage can not be greater than the maximum input range.2. Output power can not be greater than the maximum load for a long …
1080P 5MP 160 Fish Eye Surveillance Camera Module for Raspberry Pi with IR Night Vision
$34.43Raspberry Pi & Orange PiAdd to cartFeatures– This is the new version, can replace the infrared lamp or white fill light, the effect is great.– The Raspberry Pi Camera Board Features a 5 million pixels– And also supports 1080p @ 30 fps, 720p @ 60 fps and 640*480p 60/90 video recording.– OmniVision 5647 sensor in a fixed focus module.– The module …
1080P 5MP 160 Fish Eye Surveillance Camera Module for Raspberry Pi with IR Night VisionRead More
STM32H743VIT6 STM32H7 Development Board STM32 System Board M7 Core Board TFT interface with USB Cable
$58.95Motherboard & Development BoardAdd to cart>>>STM32H750VBT6 Manual:Click here to open>>>STM32H743VIT6 Manual:Click here to openhttp://myosuploads3.hobbyant.com/products/20200410/20200410051631STM32H750HAL-1909.rarhttp://myosuploads3.hobbyant.com/products/20200410/20200410020657STM32H743HAL-1909.rarSpecificationsFrequency:400M (M7 core)Package:LQFP100RAM:1024KBFlash:H750VB:128KB H743VI:2048KB (2M)OLED interface – plug and play, support 0.96 inch / 1.3 inch OLED TFT liquid crystal interfaceConnect 1.3 inch HD full color LCDConnect 2.0 inch HD full color LCD Data storage:W25Q64 (QSPI driver)High speed crystal:25MHZLow frequency crystal:32.768KPower + programmable LED lights2 users and …
2.5 inch 60mm LED Turbo Boost Gauge Vacuum Press Pressure Bar Dials Meter for Car Truck
$99.21Switch AccessoriesAdd to cartSpecifications Material:Aluminum+ABS+Acrylic Power:DC(10-15V) 12V Professional Reads Range:-1~2 BAR Light Colour:White + Red Diameter:2.5 Inch /60mm Packing Size:15 x 8 x 11cm Features 270 degree sweep. Illuminated red needle display. LED Backlight display between white and red light are switched by the button. When the pressure alarm, peak light becomes red, the pressure alarm point can …
2.5 inch 60mm LED Turbo Boost Gauge Vacuum Press Pressure Bar Dials Meter for Car TruckRead More
5pcs JDY-16 bluetooth 4.2 Module Low Power High Speed Data Transfer Mode BLE Module
$28.46Other Module BoardAdd to cartDescriptionJDY-16 Version supports(WeChat, APP, Android) Transparent, IO, RTC, PWM and other functions1.BLE high speed transparent transmission supports 8K Bytes rate communication2.Send and receive data without byte limit, support 115200 baud rate often send and receive data3.Support 3 modes of work4.Support(serial port, IO, APP) sleep wake up5.Support Wechat Airsync, Wechat applet and APP communication6.Support 4 channel …
5pcs JDY-16 bluetooth 4.2 Module Low Power High Speed Data Transfer Mode BLE ModuleRead More
Reviews
There are no reviews yet.