CC2530F256RHAR cc2530 Module Serial Port Transparent Transmission with ZB502 Development Board Kit

Note
At least two CC2530 modules are needed to realize Z1gBee networking, this product contains only one.
Two methods can be used
Application method:(The bottom layer is implemented by the board, you only do the application)
Use the firmware associated with the board. In this way, the board is a Z1gBee wireless serial port module, the operation is as simple as operating the serial port, you do not need to understand the complex Z1gBee protocol.
Development method:(Re-develop the board and implement the bottom layer yourself)
Write your own Z1gBee communication protocol. In this way, you need CC Debugger, etc., you also need to learn and understand the complex Z1gBee protocol.
Serial port related
Operation is as simple as operating the serial port
Support three kinds of serial port transparent transmission firmware:coordinator, router and terminal
The factory default configuration is a router (by downloading the coordinator or terminal firmware, it can be changed to the coordinator or terminal)
Support serial port to send big data packets and broadcast fast packet sending
Support serial port download program (firmware supports serial port bootloader; serial port module required)
Support the host computer software to set working mode, serial channel, baud rate, channel and other parameters
Other
Supports automatic networking (at least one coordinator and one router are required for networking)
Real-time monitoring of the signal strength between the coordinator, routing and terminal
With RXF2401 power amplifier
Parameter
Main control chip:CC2530F256RHAR
Communication distance:communicable:over 1500 meters; reliable communication over 1300 meters; automatic reconnection:over 1000 meters (working environment:open area)
Working frequency band:2.4GHz
Working voltage:2.0V-3.6V
Temperature range:-40→∥85→
Serial port baud rate:38400bps (default), can be set to other baud rate
Interface:All I/O interfaces except P1_1 and P1_4
Interface spacing:pin spacing:2.54mm; pin spacing on both sides 22.86mm (9×2.54)
Antenna:Use 2.4G, 2DB omnidirectional antenna
CC2530F256 Core Parameters
Working frequency band:2.4GHz
16 transmission channels, switch reliable communication channels according to the environment
Wireless transmission rate up to 250kbps
High-performance, low-power 8051 microcontroller core
RF transceiver for 2.4GHz IEEE 802.15.4
Wide power supply voltage range (2.0∥3.6V)
Watchdog, battery monitor and temperature sensor
12-bit ADC with 8 inputs
2 USARTs supporting multiple serial communication protocols, 1 infrared generating circuit
1 general purpose 16-bit and 2 8-bit timers
Advanced Encryption Standard (AES) coprocessor
21 general purpose I/O pins, 2 with 20mA current sink or current supply capability
ZB502 baseboard introduction
The onboard battery slot supports multiple power supply methods.
Lead out all IOs to facilitate user function expansion.
There is a CP2102 onboard, which is convenient for users to debug and update the program.
Onboard basic LED and buttons are convenient for users to operate.
Package includes
1 x ZB502 development board
1 x XCor 2530
1 x Antenna
1 x USB cable type A male port to mini-B male port
1 x 4PIN+2PIN cable package
Interface
1. Core board slot
2. I/O interface
3. USB interface
4. UART/SPI interface
5. 1-wire interface
6. Debug interface
7. 5V and 3.3V power input and output interface (usually used for external power supply, or common ground with user board)
Device
8. CP2102
9. AMS1117-3.3
10. Power switch
11. Serial port transceiver indicator
12. Power LED
13. User LED
14. User buttons
15. Reset button
Jumper Description
16. UART0 JMP
17. LED JMP
18. KEY JMP