10pcs 2.4G DL-LN33 Wireless Networking Board UART Serial Port Module CC2530
$108.53
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Feature
Num.:Parameter:Parameter value
1:Product number:DL-LN33
2:Chip selection:CC2530
3:Working frequency:2400~2450MHz (16 channels total)
4:Communication Interface:UART serial port (supports 13 baud rates, 2400, 4800, 9600, 14400, 19200, 28800, 38400, 57600, 115200, 230400, 125000, 250000, 500000)
5:Self-organizing network hops
6:Single hop transmission distance:70 meters (out of the air, no occlusion test)
7:Number of points that can be accommodated:The typical value is 190. When the network tends to be dense, the number of nodes decreases, and the minimum value is 96.
8:MAX packet length:63Byte (including port address information)
9:Transmission capacity:The transmission rate is higher when only one node sends data
Because the routing information of the transmitted packet occupies a certain bandwidth, the longer the length of each packet, the higher the transmission efficiency.
2400 Bit/s when each package contains 3 bytes of data.
10KBit/s when each package contains 30 bytes of data.
13:MAX send rate:250KBit/s
14:Packet retransmission times:Up to 15 times, at least 5 times when the network load is high
15:Air delay:Single-hop between nodes, less than 10mS
16:Transmit power:4. 5dBm
17:Operating Voltage:2. 5V~3. 6V
18:Working current:Less than 30mA
19:Antenna interface:PCB antenna
Pin Descriptions
Pin name:Pin position:Significance
NoUsed:1, 2,10,11,13:Not used, please keep it empty (empty refers to not connected to any circuit)
TestMode:3:Test mode, when working in normal mode in empty, grounding works in test mode. Please use it empty when the user is using it.
TestTx:4:Enter test information in test mode, which will be output as a controllable IO port when the user uses it.
TestRx:5:Enter test information in test mode, which will be output as a controllable IO port when the user uses it.
Gnd:6, 9,16:Ground
Vcc:7,8:Power supply
BaudReset:12:If this pin is grounded first and then the module is started, the module will force a 115200 default baud rate to operate. In this mode, the baud rate of the module can be read or set. The baud rate read is the baud rate previously set by the module, not 115200. If the baud rate setting is not performed, the module will be restarted again. Work with the previously set baud rate.
Tx:14:Uart output of the module
Rx:15:Uart input of the module
Package includes
10 x Wireless Networking Board
Weight | 0.06 kg |
---|
Customers Also Viewed
200pcs 20cm Male to Male Color Breadboard Jumper Cable Dupont Wire
$16.16Electronic Accessories & SuppliesAdd to cartDescription Durable and reusable Easy to install and use A popular choice for construction or repair Be used for electronic project and Genuine product. Specification Length:20cm Quantity:five row of 40 roots 1p-1p pin male to male header Compatible with 2.54mm spacing pin headers Package includes 200 x male to male jumper wire
3pcs ESP8266 ESP-12S Remote Serial Port WIFI Transceiver Wireless Module
$29.04Smart ModuleAdd to cartDescriptionBased on ESP8266 wifi ICFully compatible with forepast versions ESP-12E, or ESP12FFCC&CE&RoHS all passedLow-power consumptionFurther improved antenna design, better signal performanceCan refer to ESP-12F for other infosPackage included3 x ESP-12S Wireless Module
96Pcs Chicken Plucker Fingers Rubber Poultry Duck Turkey Goose Feather Plucking Glue Stick
$99.21Solar CollectorsAdd to cartFeatures-The glue stick has the advantages of high wear resistance, soft texture, large elasticity, no easy breaking, good hair removal effect, low skin breaking rate and the like.-Widely used in chickens, ducks, geese and other slaughter equipment.SpecificationName:Chicken PluckerMaterial:Nat-rubberColor:Yellow or BlackSizes:20 x 65mmPackage included96 x Chicken Plucker glue stickNoteSilicone products, the edge is expected to belong …
96Pcs Chicken Plucker Fingers Rubber Poultry Duck Turkey Goose Feather Plucking Glue StickRead More
10pcs 1838T infrared Sensor Receiver Module Board Remote Controller IR Sensor with Cable
$31.47Sensor & Detector ModuleAdd to cartFeatures– Can receive standard 38KHz remote control signals by means of programming can decode the remote control signals– Strong ability to resist electromagnetic interference and light– Widely used in stereo, TV, set-top boxes, digital photo frame, car stereo, remote control toys, satellite receivers, hard disk players, air conditioner, heater, electric fan, lighting and other home …
10pcs 1838T infrared Sensor Receiver Module Board Remote Controller IR Sensor with CableRead More
3pcs CC1101-868MHz 2-3.6V RF Low Power UHF Wireless Transceiver Module 1.2K To 500kps 64 Bytes SPI
$29.02Smart ModuleAdd to cartDescriptionThe CC1101-868MHz RF module is low cost and highly integrated UHF transceiver designed for low power wireless applications. These pro certificate modules, operating in the license free 868 MHz ISM band, can be easily integrated into your application, thereby reducing development time and cost.FeaturesLow power UHF wireless transceivers @868MHzSupport FSK, GFSK, ASK/OOK and MSKConfigurable data …
Geekcreit Upgrade DIY EC1515B DS1302 Light Control Rotation LED Electronic Clock Kit Size 81x81x2mm
$13.11DIY Electronic KitsAdd to cartDesign Red digital tube+ Red & Green LED with housing / Design Red digital tube+ Red & Blue LED with housing / Design Red digital tube+ Red & Blue LED without housing / Design Red digital tube+ Red & Green LED without housing / Design Blue digital tube+ Red & G
Reviews
There are no reviews yet.