10pcs Electronic DIY LED Dimming Lights Series and Parallel Circuit Technology Small Production Kit
$29.32
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Description
The purpose of the experiment
1. Understand and recognize the light-emitting diodes and illuminate the light-emitting diodes (LEDs);
2. Understand the role of understanding resistance, series and parallel resistance;
3. Understand the self-locking switch;
4. Understand and recognize adjustable resistors and use adjustable resistors;
Experimental steps
Step 1:The long leg of the light-emitting diode (LED) is the positive pole, and the short leg is the negative pole. First, the long wire of the LED is connected to the black wire (negative electrode) of the battery case, and the short leg of the LED is connected to the red wire (positive electrode) of the battery case. At this time, the light emitting diode (LED) is not lit. Then send it over again, let the long leg of the LED connect to the red line of the battery box, and the short leg of the LED is connected to the black line of the battery box. At this time, the LED lights up, indicating that the LED is in one-way operation and the single-pass characteristic of the diode .
Step 2:In the circuit of the experimental step 1, a resistor of 220 ohms is inserted in series, and the brightness of the LED lamp is lowered, and the resistance hinders the current.
Step 3:Connect a 220 ohm resistor in parallel with the resistance in the circuit of the experimental board 2. The brightness of the LED is increased, indicating that the total resistance of the resistor in the circuit is reduced after the resistors are connected in parallel.
Step 4:Change the two resistors of the experimental step 3 from parallel to series. After the series connection, the brightness of the LED lamp is the lowest. After the series connection of the resistors, the total resistance of the resistor in the circuit increases.
Step 5:Replace the original resistor with a potentiometer. The potentiometer has 3 feet, and the resistance of pins 1 and 3 is fixed. The resistance of pins 1 and 2, 2 feet and 3 feet can be changed by adjusting the potentiometer knob. When experimenting, you can pick up 2 of them. The foot has to experiment many times, adjust the potentiometer knob to observe the change of LED brightness, so that you can fully understand the potentiometer.
Step 6:Know the self-locking. Press and wait for the light to be on, then press the light to turn off.
Package included
10 x DIY LED Dimming Lights Technology Small Production Kit
Weight | 0.27 kg |
---|
Customers Also Viewed
WEAH-307 3 Way Audio Speaker Crossover 100W Filter Treble Mediant Bass Frequency Divider Module
$15.30Amplifier BoardAdd to cartFeatureMode:WEAH-307Power:100WImpedance:4-8ohmCompatible for:Under 6inches HornTreble Standard:12db/octBass Standard:12db/octSize:8.5×6.2×2.6cmFrequency response:low 45Hz, high 20KHzPackage includes1 x 100W Filter Treble Mediant Bass Frequency Divider
3pcs WXD3-13-2W Precision Potentiometer 22K 22K Ohm Wirewound Multi-Turn Potentiometer
$10.49Module ComponentsAdd to cartSpecificationsResistance range:22K┯Resistance tolerance:÷ 5%Rotation angle:3600 ÷ 20 Number of laps:10 lapsRated voltage:160VStarting torque:3.5 ~ 100mN.mRated power:2W (85 →) 0W (125 →)Linearity accuracy:÷ 0.3%Mechanical durability:10,000 weeksPackage included3 x Potentiometer
20Pcs Serial Port WIFI ESP8266 Module Adapter Plate with IO Lead Out for ESP-07 ESP-08 ESP-12
$12.02Smart ModuleAdd to cart20Pcs Serial Port WIFI ESP8266 Module Adapter Plate With IO Lead Out For ESP-07 ESP-08 ESP-12This Adapter Plate is for ESP-07 ESP-08 ESP-12, a test board with IO lead out.NoteNeed to solder 3V regulator by youself.ESP-07, ESP-08, ESP-12 module board are not included!!!Package included20 x Serial Port WIFI ESP8266 Module Adapter Plate40 x Pins
10pcs 2S 5A Li-ion Lithium Battery 7.4V 8.4V 18650 Charger Protection Board BMS for Li-ion Lipo Battery
$16.88Battery Protection ModuleAdd to cartSpecificationsModel:HX-2S-A2 Overcharge voltage range:4.25-4.35v ± 0.05vSize:17.5 * 17.5 * 3.2mm over discharge voltage range:2.5-3.0v ± 0.05vUpper limit operating current:5A Operating temperature:-40 — +50 °Upper limit instantaneous current:7A Storage conditions:-40– +80 °Quiescent current:less than 10uA Effective life:more than 50,000 hoursInternal resistance:less than 300mΩ Short circuit protection:can be protected, need to charge recoveryCharging voltage:8.4V-9VWelding point DescriptionB + …
DC 24V 600L/H Submersible Pump Immersible Pump Under Water Pump Bath Pump
$42.51Electrical Pump & ValveAdd to cartSubmersible Pump Immersible Pump Under Water Aquarium Bath Pump DC 24V 600L/HSpecificationColor:GreyUse:SubmersibleMaterial:Engineering ABSRated Voltage:DC 24VStarting Voltage:6VCurrent:0.75AFlow:600L/HNoise:50dB MAXMax. Head:500cmPower:18wWaterproof grade:IP68Motor:brush motorWater temperature:-20 ° C ~ 60 ° ° CAmbient humidity:45%~90%No load current:less than 0.2ACurrent at load:1.2ACable:1.5m /59.06inch(appr.)Total Length:105.9mm /4.31inch(appr.)FeaturesBrand New and high quality.Suitable for tap water, sea water, ground waterCannot be used directly with 220V AC …
DC 24V 600L/H Submersible Pump Immersible Pump Under Water Pump Bath PumpRead More
TDA7498 2.1 Digital Power Amplifier Board 200W+100W+100W Supasses TPA3116 Class D DC24V
$70.06Amplifier BoardAdd to cartFeatures-Using original TDA7498 TL072-The front input capacitor and the inter-stage coupling capacitor use Siemens’ top-level capacitors 1UF, the electrolytic capacitor signal main circuit uses Taiwanese famous brands, and the main filter capacitor uses special electrolytic capacitors 2≠2200UF to ensure strong continuous power support.-The resistors are high-precision chip resistors, and the main circuit uses five-ring metal …
TDA7498 2.1 Digital Power Amplifier Board 200W+100W+100W Supasses TPA3116 Class D DC24VRead More
3Pcs RobotDyn RTC DS1307 Real Time Clock Battery Shield with Pin Headers Set
$18.67Expansion Board & ShieldAdd to cartPINOUT:http://img.staticbg.com/file/products/20171226001032PINOUT-RTCDS1307.pdfSchematic:http://img.staticbg.com/file/products/20171226001140Schematic-RTCDS1307.pdfFeatureType:Logic ICsPackage includes3 x RTC DS1307 (real time clock) + battery3 x Wemos D1 mini shield6 x Male Pin Header 8pins6 x Female Pin Header -BLACK 8pins6 x Stackable Header – BLACK 8pins
Reviews
There are no reviews yet.