KEYES RT5350 Openwrt Router WiFi Wireless Video Expansion Board for Raspberry Pi
$37.81
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Description
RT5350 SoC combines Ralink’s IE802.11n draft compatible with 1T1R M A C/BBP/PA/RF, high performance 360 MHZ MIPS24KEc CPU core, 5 ports integrated 10/100 Ethernet switch/PHY and USB host/device. Very few external components are required to use RT5350,2.4 GHz 802.11n Wireless products.
RT5350 uses Ralink’s second generation 802.11n technology to achieve a longer range and better throughput. Embedded high-performance CPUs can easily manage advanced applications, such as WIFI data processing, without overloading the host processor. In addition, RT5350 also provides various hardware interfaces (SPI/I2S/I2C/PCM/UART/USB) to support a range of possible applications.
Support 16-bit SDR SDRAM (maximum 64MB).
Support booting from ROM, FLASH.
USB2.0 protocol.
Specification
1. Embedded 1T1R 2.4G CMOS RF
2. Embedded 802.11n 1T1R with MLD Enhanced M A C / BBP
3. Embedded PA / LNA
4. 150 Mbps PHY data rate
5. 20 Mhz / 40 MHz channel width
6. Traditional and high overall mode
7. Compression block AGK
8. bluetooth coexistence
9. Multiple BSSIDs (up to 16)
10. WEP64 / 128, WPA, WPA2, WAPI engine
11. Q0S – WMM, WMM power saving
12. Hardware Frame Aggregation
13. Support 802.11h TPG
14. MIPS 24KEc 360 Mhz with 32 KB I cache / 16 KB D cache
15. Support 16-bit SDR SDRAM (up to 64 MB)
16. Support boot from ROM, FLASH
17. USB 2.0 HOST / Set i• Dual Mode x1
18. Embedded 5-port 10/100 Mbps Ethernet Switch and 5-Port UTP PHY
19. Support 5 10/100 UTP ports
20. Low Speed I / 0:GPIO, SPI, I2C, I2S, PCM, UART and JTAG
21. Package and I / 0 voltage
22. I / 0:3.3 V I / 0
Package Included
1 x Expansion Board
1 x RT5350 Module
Weight | 0.041 kg |
---|
Customers Also Viewed
DC12V 0.02-0.8MPa Solenoid Valve for Solar Water Heater
$21.87Laboratory Heating EquipmentsAdd to cartDC12V 0.02-0.8MPa Solenoid Valve for Solar Water HeaterSpecificationsModel:SSG-2Type:Normally ClosedMaterials:Plastic & CopperDimension:83*90*49cmPipe Inside Diameter:1/2 inchNet Weight:(approx.) 190gFeaturesThis is a DC12V solenoid valve usually used for solar water heater.It can work with water from 1 to 100℃ (or some other liquid).Working Voltage Range:Rated Voltage ±10%Working Water Pressure:0.02 to 0.8MpaThe working water pressure would be too low/high to …
DC12V 0.02-0.8MPa Solenoid Valve for Solar Water HeaterRead More
650 Pcs Assorted Ring insulated Electrical Wire Terminals Crimp Connector Set Kit
$76.17Terminal BlocksAdd to cartDescription650 Pcs Assorted Ring Insulated Electrical Wire Terminals Crimp Connector Set KitSpecificationQuantity:650PcsMaterial:Copper + PVC+ TinplateInsulated crimp terminals.All are enclosed in plastic case for easy access.The assorted crimp terminals is including50 x Ring M3 Red50 x Ring M4 Red50 x Ring M5 Red50 x Ring M6 Red50 x Ring M8 Red50 x Ring M4 Blue50 x …
650 Pcs Assorted Ring insulated Electrical Wire Terminals Crimp Connector Set KitRead More
3.5 inch Protective Enclosure Case Support Dispaly Screen or Cooling Fan for Raspberry Pi
$9.26Raspberry Pi & Orange PiAdd to cartFeatures– Fully updated for Raspberry Pi 3B+/3B/2B– Can support 3.5 inch screen or cooling fan (notes:can not assemble them at the same time)– Heat sink openings for both CPU and LAN chip– High-gloss finish, surface mountableSpecificationsColor:BlackMaterial:ABSSuitable for Raspberry Pi 3B+/3B/2BWeight:45gSize:9cm*6.2cm*3.4cmPackage Included1x ABS Case4x Non-slip mat4x Screws
20pcs 0.56 inch Digital Tube DIY Kit TM1650 4-digit LED Digital Tube Display Module for
$47.25DIY Electronic KitsAdd to cartDescription1. Use TM1650 (compatible with AIP650) digital tube driver chip, support 8-level brightness adjustment, working voltage 3.3V ~ 5.5V2. IIC interface, only need 2 ordinary IO can drive, do not need to repeat scanning of MCU, saving MCU resources.3. 4 digit 0.56 inch red common negative digital tube with decimal point.4. 0.56 inch with four …
20pcs 0.56 inch Digital Tube DIY Kit TM1650 4-digit LED Digital Tube Display Module forRead More
WEAH-81 Car Heavy Bass Frequency Divider High and Low 2-way 2 Bass Crossover Upgrade Tool
$33.09Amplifier BoardAdd to cartFeatureBrand:WEAHModel:81Power:100WApplicable impedance:4-8ohmFrequency response:100Hz ~ 45HzDimensions:133 x 95 x 44mmApplication environment:Car or home speaker DIYPackage includes1 x Bass Frequency DividerHow to Wire:
5pcs 8-36W intelligent Sensor LED Ceiling Light And Sound Control Power Supply Module Bulb Panel Light Built-in Power Driver
$21.42Power Supply ModuleAdd to cartDescriptionInput Voltage:AC185-265VOutput Current:0.22AOutput Voltage:24-108VEfficiency:90%Working Frequency:50/60HZOutput Power:8-24WSound Control:50-75dBLight control:7-20LuxDiameter:25.8mmFeature1. The combination of sound and light control, when the light is strong, does not work, the light intensity is lower than 12-15LUX, and the sound of the induction 27-36DB starts automatically.2. Delay 40-60S automatically extinguished, easy to install, compatible with ordinary switches, no additional wiring.3. Single trigger, …
Reviews
There are no reviews yet.