SI24R1 NF-01-S 2.4G Wireless Serial Module Transparent Transmission
$6.55
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Description
NF-01-S is a 100mW power 2.4G wireless module, high-altitude rate (up to 2Mbps), using SPI interface, send and receive in one pure hardware module; high stability, cost performance, Volume, use of all-industry components.
Has been mass production and reached millions of shipments, and applies to a variety of application scenarios.
NF-01-S can be widely used in a variety of networking occasions, suitable for wireless mouse and keyboard, wireless remote control, somatosensory equipment, active RFID, NFC, low power consumption network of wireless sensor networks, is the ideal solution of Internet of Things application.
NF-01-S adopt DIP-8 package, whether learning or mass production, can quickly docked to existing products, no need soldering, direct plug, easy to use.
Information link:http://wiki.ai-thinker.com/2.4g
Features
• DIP-8 ultra-small package, built-in 2.4G antenna, small size, easy to use
• Supports data reception for six channels
• Supports common modulation such as GFSK / FSK
• Supports 2Mbps / 1Mbps / 250Kbps data rate
•Multi-frequency:126 frequency, to meet the needs of multi-point communication and frequency hopping communication
• Internal integration of high PSRR LDOs
• Wide supply voltage range:1.9 ~ 3.6V
• Average emission current as low as 110mA
• Receiver sensitivity:-96dBm @ 250kbps
• Maximum transmit power:+ 7dBm
• Four-wire SPI interface for up to 10MHz
• Internal Integrated Smart ARQ Baseband Protocol Engine
• Transmit data hardware interrupt output
• Supports 1bit RSSI output
• Low application cost:The SI24R1 integrates all the high-speed signal processing parts associated with the RF protocol, such as automatic retransmission of lost packets and automatic generation of response signals. The SPI interface of the SI24R1 can be connected using the microcontroller’s SPI port or using the microcontroller I / O port to simulate, the internal FIFO can be with a variety of high and low speed microprocessor interface, easy to use low-cost single-chip.
• Easy to develop:Since the link layer is fully integrated on the module, it is very easy to develop. Automatic retransmission function, automatic detection and retransmission of lost packets, retransmission time and the number of retransmission software can automatically control the automatic response is not received a reply signal packet automatic response function, after receiving the valid data, the module automatically sends a response Signal, no additional programming Carrier detection – Fixed frequency detection Built-in hardware CRC error detection and point-to-multipoint communication Address control Packet transmission error Counter and carrier detection function can be used for frequency hopping settings can be set at six simultaneous receive channel address, can be selective Of the open receiving channel standard pin DIP 2.54mm pitch interface for easy embedded applications.
Parameter
Model:NF-01-S
Package:DIP-8
Size:28.6*15.3*3.2 mm
Communication Interface:SPI (The maximum rate of up to 10Mbps)
Air rate:250k~2Mbps, 3 Level adjustable(250kbps,1Mbps,2Mbps)
Spectral range:2400MHz~2525MHz adjustable, 1MHz Step forward
Antenna form:Onboard PCB antenna, gain 2dBi
Maximum transmit power:7dBm
Receiving sensitivity:-96dBm@250kbps
Average current:Emission current:25mA(7dBm)
Receive current:15mA (2Mbps)
Shutdown:current 1.0uA(Shutdown Mode)
Power supply range:1.9~3.6V, Typical value 3.3V
Operating temperature:-20 → ~ 85 →
Storage environment:-20 → ~ 90 → ,
Pin Explanation
NO.:Name:Direction:Use
1:VCC:-:Power supply, must be between 2.0 ~ 3.6V
2:GND:-:Ground, connected to the power supply reference ground
3:CSN:Input:The module chip select pin, is used to start an SPI communication
4:CE:Input:Module control pin
5:MOSI:Input:Module SPI data input pin
6:SCK:Input:Module SPI bus clock
7:IRQ:Output:Module interrupt signal output, low level active
8:MISO:Output:Module SPI data output pin
Package included
1 x SI24R1 NF-01-S 2.4G Wireless Serial Module
Weight | 0.001 kg |
---|
Customers Also Viewed
10Pcs 5V-30V Wide Voltage Trigger Delay Timer Relay Conduction Relay Module Time Delay Switch
$48.30Relay ModuleAdd to cartDescriptionWide voltage 5V-30VTime can be adjusted via a potentiometer, meeting your most occasionsMicro USB 5.0V power supply with input, easy to use5–30V wide supply voltageExternal triggering and onboard buttons Two triggering methodsWith a relay pull-in indicatorInterference ability, under various interference will not malfunction relay for industrial control.Module features1. Working voltage:Wide voltage any voltage between 5-30V, …
110-220V 150W Foldable Electric Cloth Hanger Travel Heating Dryer Drying Rack
$46.56Switch AccessoriesAdd to cartFeatures1. 3-hours fast drying. Use clothes to form a wind hood, so that the hot air flow gathers inside the clothes and circulates to achieve the purpose of fast drying.2. Dual mode, cold and hot air switching. It will automatic conver to cold air after 3h hot air drying.3. PTC heating, low power consumption, safe …
110-220V 150W Foldable Electric Cloth Hanger Travel Heating Dryer Drying RackRead More
20Pcs 10ml Metal Needle Empty Plastic Bottle Shisha E Cig Liquid Dropper
$19.08Bottles & JarsAdd to cartDescription20Pcs 10ml Metal Needle Empty Plastic Bottle Shisha E Cig Liquid Dropper SpecificationsMaterial:PECapacity:10mlSize:20X77mm / 0.79X3.0 inchNeedle Size:Inner Diameter =0.8mm, Outer Diameter =1.2mm, Length=12mmQuantity:20 pcsFeatures1. 10ml empty plastic bottle with metal needle2. Metal needle design,durable and easy to use3. Ideal for storing E cig liquid,solvents, light oils , eye drops, saline, etc.Package included20 X 10ml Empty …
20Pcs 10ml Metal Needle Empty Plastic Bottle Shisha E Cig Liquid DropperRead More
3Pcs AC-DC 3.5W Isolated AC 110V / 220V To DC 3.3V 1A Switch Power Supply Converter Module
$19.93Power Supply ModuleAdd to cartDescriptionsThe power supply is isolated industrial grade built-in power module with temperature protection, overcurrent and short circuit full protection.FeaturesAC85 – 264V or DC110 – 370V wide voltage inputDC3.3V(+/ -1%) 1A isolated outputInput Current:0.5mA/115VAC 0.25mA/230VACInput surge current:10A (230VAC)Frequency range:47-63HzOperating Temperature:-30 – 70 →Relative humidity:20%- 90%Rated power:3.5WOutput efficiency:61%Module size:5.1*2.3*1.8cmPackage included3 x AC-DC 3.5W Isolated AC 110V / …
3Pcs AC-DC 3.5W Isolated AC 110V / 220V To DC 3.3V 1A Switch Power Supply Converter ModuleRead More
3Pcs XL4015 5A DC-DC Step Down Adjustable Power Supply Module Buck Converter
$16.35Boost & Buck ModuleAdd to cartSpecificationModule highlights:5A high power, high efficiency and low ripple with power indicatorModule Properties:non-isolated buck module (BUCK)Input voltage:8-36V (input please try not to exceed 38V)Output voltage:1.25-32V continuously adjustableOutput Current:0-5AOutput Power:75WOperating temperature:-40 to +85 degreesOperating frequency:180KHzConversion efficiency:up to 96%Load regulation:S (I) ≤0.8% (input 24V, output 12V, load varies from 1 ~ 4.5A measured)Voltage Regulation:S (u) ≤0.8% (output …
3Pcs XL4015 5A DC-DC Step Down Adjustable Power Supply Module Buck ConverterRead More
Reviews
There are no reviews yet.