DC 12V-36V 15A 500W Brushless Motor Controller BLDC Driver Board Stall Over-current Protection
$30.60
Shipping:Standard Shipping about 10-25 business days
Secure Payment:Paypal,VISA,MasterCard
Specification
Operating voltage:DC 12V-36V
Operating Current
Driver Power
Speed Voltage:0.1V-5V
Operating Temperature:-40~85°C
Humidity:90%RH
Stall protection:Yes
Enable Control:Yes
Over-current protection:Yes
Steering control:Yes
Speed control signal:Yes
Size:63 x 42 x 17mm (L x W x H); Probe size 3mm, length:fixing hole center distance 57mm; width:fixed hole center distance 36.5mm
Power terminal Out
VCC(positive power supply)
GND(negative one)
MC(motor phases W)
MB(motor phases V)
MA(motor phase U)
Set for the control side
GND:control terminal ground
VR:the governor end 0-5V(corresponding to 10% of motor speed -100%)
ZF:reversing control(connected to 5V or ground can charge the motor rotation direction)
M:tachometer pulse output(depending on the number of motor poles corresponding to the number of pulse per revolution of the output number)
EL:enable control terminal(connected to 5V ot ground running then 5V, grounding the motor stops)
5V:5V control terminal
Wiring
Control terminal for SET
1. The motor speed control wiring methods:available potentiometer system speed can also be connected to the MCU control, when the potentiometer control wiring, the potentiometer middle pin is connected to VR speed port, potentiometer connected to both ends of 5V and GND terminal voltage more high speed faster.
2. Motor steering control wiring methods:you can switch control can also be connected to the MCU control, to GND in one direction, then in one direction 5V.
3. Pulse speed signal:high and low output . IC can not understand the information with the customer request.
Note
Motor driver board 12-36V DC power input, VCC positive power supply,GND power supply is negative.
Electrical wiring methods:Brushless DC motor for the three lines, corresponding MA/U, MB/V, MC/W
Tips
If you use less than 60W, without additional heat sink , be sure to add more than 60W
heatsink fins drive efficiency without lowering the temperature is too high will shine into permanent damage! The size of the heat sink may be a bad environment based work(recommended cooling surface area greater than 200 square centimeters)!When installing the heat sink ,must pay attention to the back of the module 6 MOS pipe insulation, no insulation, it will be adhered to drive plate permanently damaged! Proposes to add insulation films, both sides of the insulating sheet plus thermal grease!
Package Includes
1 x 12-36V 500W Brushless Motor Controler
Weight | 0.027 kg |
---|
Customers Also Viewed
150W 18V Mono Solar Panel Dual USB 12V/5V DC Monocrystalline Solar Charger for Car RV Boat Battery Charger Waterproof
$164.01Solar PanelAdd to cart150W 18V Mono Solar Panel Dual USB 12V/5V DC Monocrystalline Flexible Solar Charger For Car RV Boat Battery ChargerFeatures1.Equipped with 12V DC5.5×2.1 & 5V USB output interface.2.Dedicated for 12V battery and 5V device charging.3.EVA+PET at front panel, flexible, light-weight but durable.4.Mono-crystalline solar Cell with efficient up to 21%.5.4x eyelet and free 2x carabiners for mounting …
DIY 5×7 Prototype Paper PCB Universal Experiment Matrix Circuit Board
$4.36Module ComponentsAdd to cartDescriptionMaterial:Single Side Copper PCB.Hole Dia:about 1mm.Hole pitch:standard 2.54mm.For point to point DIY soldering.Size:5cm x 7cm – 1.97inch x 2.76inch.Quantity:1PCPackage Included1 x PCB Board
FR4 300x200mm Double Side Copper Clad Laminate PCB Board Fiberboard CCL
$17.48Other Module BoardAdd to cartFR4 300x200mm Double Side Copper Clad Laminate PCB Board Fiberboard CCLSpecificationPanel Size:Approx. 300mm x 200mm or 11.8inch x 7.88inch (inch)Thickness:0.06inch ±0.005 (1.5mm ± 0.15)Weight:Approx. 194g eachLayers:Double SidePanel:FR4Operating temperature:Up to 140 °C or 285°FDescriptionThis Double PCB Copper Clad Laminate Board is made of copper foil by the hot-pressing technology.Super-fine steel-wool, Restore4, Tarn-X, roscherite, Zap or similar …
FR4 300x200mm Double Side Copper Clad Laminate PCB Board Fiberboard CCLRead More
10pcs DC Jack Power 7~12V to DC5V/3.3V Step Down Converter Voltage Regulator Power Supply Module for Breadboad OPEN-SMART for Arduino – products that work with official for Arduino boards
$34.43Power Supply ModuleAdd to cartSize ConversionInchesCentimetersPlease according to your own measurements to choose your suitable size. The tags inside the items will show in our Asian (Type) size.DescriptionThis is a mini LDO step-down power module based on AMS1117-5.0 and AMS1117-3.3, and it output fixed 5V / 3.3V.It is a small size, lightweight, especially for model airplanes, smart cars, DIY …
60A DC Brush Motor Speed Controller forward Reverse PWM Control Pulse Width Speed Digital Display 10-55V/3KW
$69.50Motor PWM Speed ControllerAdd to cartThe main purpose1. All kinds of general-purpose DC brush motor speed control2. Various types of automotive motor speed control (automobile cooling fan speed control, car fan speed control, car wiper motor speed control, car air conditioning fan speed control)3. Production line conveyor speed control, pipeline exhaust fan speed regulation, treadmill speed regulation, multiple computer fan …
24Value 500Pcs 0.1uF-1000uF Electrolytic Capacitors + 10Value 600 Pcs 0.1uF-10uF Ceramic Capacitor Assortment Box Kit
$32.79Module ComponentsAdd to cartProduct FeaturesThe nice sturdy box helps you keep all caps in order.Assortment Box for easy access.All of the capacitor is marked the value,easy to find what you need.High quality and long life. Package Included1 x 10Value 600pcs Ceramic Capacitor1 x 24Value 500pcs Electrolytic Capacitor
5Pcs KY-015 DHT11 Temperature Humidity Sensor Module
$17.16Sensor & Detector ModuleAdd to cart5Pcs KY-015 DHT11 Temperature Humidity Sensor Module ForDescriptionThe sensor module is including resistive humidity sensing component and NTC temperature testingThe compatible digital temperature humidity sensor module is component and connected with 8-byte MCUGreat anti-interference ability and durableWith fixed bolt hole for easy installation3 DO small plate switch digital output interface connected microcontroller IO portTwo module …
5Pcs KY-015 DHT11 Temperature Humidity Sensor ModuleRead More
100pcs 270uF 16V 8x8mm Low ESR 16V270uF for Motherboard VGA Solid Capacitor
$29.08Electronic Accessories & SuppliesAdd to cartDescriptionLow ESR, high ripple current capabilityESR 5mΩ max (2 to 4VDC)Longer life(20000 hours at 106 Celsius)Rated voltage:2 to 16VDCCategory temperature:-55 to +105 CelsiusTolerance:+/-20%(M)Package included100 x Solid Capacitors
Reviews
There are no reviews yet.